Separate names with a comma.
bob, I'm not a 5 year welder or a welder at all, my questions is if you preclean your tubing 1-2'' weld it -- preclean your tubing 1/2'' weld...
please expain more about the weight transfer, with more or less angle, moving the engine up or down on it center line does it also change the...
you have me thinking again- we run jr. fuel, 396 sb chevy all steel. dyno pulls, 145* engine temp 911 hp, fatten it up - 919 hp 145*temp lean...
sorry chassic ?
very good point on the bearing "tang" as we call it. I will check it to make sure there is enough room. We are running a blown alky motor, it is...
blown375 thanks very much I understand what ya'll are saying about it, our machinist says his hone takes some out of the block and the cap,...
I have more questions than answers and it's too long to ask correctly in writing, so where can I get books on machining and/or theory on machining...
60 -75 dollars just to start it on alc. (alc.oil, filter)
thanks to all, long winter, Darren, will stop by this week sometime. again thanks to all steve m.:)
Thinking about going to gas! How much hp does alc. make over gas? I know the sound will not be the same or the smell anything else you can think...
THANKS TO ALL, I think it was the oil with the alc. Found a new machinist Help Clearance on the mains and rods?
Thanks all, Yes the hole in the block under the rear cap is tapped and plugged. The more I thing about this too, I think the bearing has been...
Thanks for the continuous input! It’s injected If the line hone was off would the thrust show lots of wear and/or all the bearings? Checked...
Thanks again, It’s injected, 10lbs of boost is more than I expected, I had it way de-tuned at 17.2 underdriven. Is there a formula to get...
THANKS FOR THE INPUT Oil is Kendal, Wet oil system, 45 psi at starts 65 psi last time I look at it going down the track Mains 1 looks very...
Thought I was taking baby steps. After seeing some junk in the oil I tore the motor down and checked the bearings on our first blown small block,...
who's main bearings are you using? thanks hotrod316
converter ballooning
