Separate names with a comma.
arias, fontana heads this engine changed to a 10 bolt configuration in the early 80's (similar to a 392) the bore spacing is...
high overdrive we used to have a low compression engine. (9.9 cr) due to time & money limits we started at 57 over. also we...
geo blimey wayne, 2" is just enough. i have sometimes run 1.950 but depends on springs. take a spring & retainer and put...
valves wayne, you are right that the geo is better w/ shorter valve. you may not have enough room for a good spring with...
sleeves you are only going .017 more per side, should be fine. the brad "pro mod" sleeve is 4.666 under the flange and 4.610...
testing dave, went testing last saturday at dinwiddie (vmp) with my top dragster guys. they will run mostly with d.c. outlaws...
rotor speed dave, that is a bunch of rotor rpm. 9800 x 1.52 is 14900 at the supercharger. oh well, i know that you go...
clearance hey 400, where are you measuring the piston diameter??? you should check it just below the oil ring and 90* from...
i really know little about this team except they sure put on a great race this weekend!! most consistant and impressive!!...
glide & brute sir, if you don't have to run a powerglide, DON'T..... they keep making better parts for them but all are...
50 % it is a major change to do this and the only aplication is pro extreme. operating costs are many times higher. MANY!!...
santo, the base torque of the engine (mostly stroke) the gearing @ hit, weight of car all effect the results. HINT, i have not...
hey, guys and specially santo s. on the converter door cars i work with there is a range (happy place) of driveshaft rpm. AT...
ditto as robert said, all plugs on all mags .014-.015 gap or you will overheat and burn out the points box. is the port...
what type of head do these fit???? it is always good to see a happy customer.
hurt skirts these are the thrust sides of the piston which would seem to indicate a very loose condition. what size are...
converter gt. you are not doing too bad for that weight and a battery type ignition! we ran around 4.60 with our last...
spin or shake it is hard to shake the little tires but it can be done. the ultimate setup for your car will depend on how...
dart heads outlaw, what type head you use should be determined by the rules you run under and your budget. i am still...
burst panel another possible cause is too small a vent on fuel tank. have seen this numerous times over the years. what are...