Separate names with a comma.
Hi Mike correct me if I’m wrong, on racepak data it shows on MSD launch the step up when I apply transbrake and it drops back when I release the...
Power from the trans brake when activated goes to the roller switch, when the throttle is depressed actually way less than 50% probably 10% it...
I’ve been using the grid since they have been available, with clutch and converter, the data shows power to the blue wire, “MSD Launch”, 2 step...
I use a button on the steering wheel and have a roller switch on the throttle pedal only gets power to the blue wire when pedal is past 50%. I...
No I haven’t, will do that, never really used review always relied on racepak.
I’ve been having some issues with my grid, on 3 occasions after releasing the button timing has failed to drop and output switch hasn’t activated....
Andre, I sent you an email about the rear ends a week or so ago with no reply, not sure if you got it, I kept up my end of the deal 100% as...
Progrind@bigpond.net.au
How much do you want for the piece?
What is the width flange to flange, what bolt pattern, does it have 4 link brackets and how much do you need for it?
Will 18v cause problems with leahy timer and fuel log? Emailed electromotion no reply as of yet.
Hi, Can you send some pics of the LB21 please and how much you need for it. Email progrind@bigpond.net.au Thanks for your time, Regards, Matt
Need complete gear set in good condition also looking for 1.50% and 2 speed cs1 case.
I'm looking to purchase 100 tall sheet metal manifold to suit fat heads, don't mind if it needs some repair, let me know what you've got.
Short block Bore, stroke, $ ???
Car won't start Most likely motor isn't cranking fast enough or timing is retarded.
Rear main seal leak When the centre cap was replaced the block was line bored, the groove that the rear main seal runs in needs to be...
I'd start with the 4.56 in the rear and run the trans as a two speed with the 55%, 10.5 inch converter from one of the good manufacturer's coan,...
Psi blower
What is the best brand and grit stone to grind flywheel hat and floaters? Can you use CBN wheels?