Search Results

Search Again
  1. AJ FED
    Post

    Max stroke 10.200 block?

    Hi rb.....I have an old hemi cast KB block and if memory serves it has a deck height of 10.700. The KB crank is +5/8" making stroke 4.375". Hope...
    Post by: AJ FED, Jan 25, 2017 in forum: PSI Superchargers Tech Questions
  2. AJ FED
    Post

    Flexplate/converter bolts/converter tabs

    The spacers are 1/8 thick x about 3/4 OD machined steel.
    Post by: AJ FED, Jan 7, 2017 in forum: PSI Superchargers Tech Questions
  3. AJ FED
    Post

    Flexplate/converter bolts/converter tabs

    Thanks Mike. My current set up uses a 1/8 spacer. I guess this may change once I replace the existing crank adaptor and flexplate with a new one...
    Post by: AJ FED, Jan 5, 2017 in forum: PSI Superchargers Tech Questions
  4. AJ FED
    Post

    Flexplate/converter bolts/converter tabs

    Thanks all for the input. My "new" converter only has 1 1/2 runs on it before converter bolt damage to the converter lugs (and flexplate and seal...
    Post by: AJ FED, Jan 5, 2017 in forum: PSI Superchargers Tech Questions
  5. AJ FED
    Post

    Flexplate/converter bolts/converter tabs

    Thanks Jody, Mike and Bednar. I really appreciate your experience. 6 bolts it is with nylon lock nuts. I see the CSR flex plates use 1/2" bolts...
    Post by: AJ FED, Jan 4, 2017 in forum: PSI Superchargers Tech Questions
  6. AJ FED
    Thread

    Flexplate/converter bolts/converter tabs

    Hello and Happy New Year! By way of introduction I have just joined however I have been reading the forum on and off for a while. What a great...
    Thread by: AJ FED, Jan 2, 2017, 15 replies, in forum: PSI Superchargers Tech Questions
Showing results 1 to 6 of 6
Search Again