Separate names with a comma.
We have a steel loop line. before he sent it off, we tested the pump with a drill on the motor and it actually pumped. last night we were bench...
for GP, is there a preferred method for checking the end play. should i make a plate that is same depth as pump, bolt on and check depth of rod...
when we put the pump on originally we checked depths and thought we had the pump end play set correctly. I think this might have to be revisited...
it does have the adjustable clamp. We will check that out for movement. another gentleman said if you can turn the pump with your fingers then...
was speaking with a knowledgeable friend about the problem and with as full as we are filling the tank the vent is covered and might not be...
Thank you, I have read that thread and have checked everything that has been mentioned in there. the motor has ran and i think a few things...
front engine dragster, MFI, what or where should fuel level be at pump with full tank? should it be right at entry (without fitting) to the pump,...
https://neilparks.com/electrical.html
ill take the gloves if you still have em. ill send pm if so.
what size are the gloves?
newb question.. Im wiring sensors up for my FED and wondering about putting a map sensor on the block to measure vac/psi. im guessing on blown...
thanks for the replies, i was looking at few sites. Impact seems to have least expensive set, even with shoes. Ill make a few calsl and see...
I wear size 14 shoe. this is my first time purchasing -20 boots. suggestions on size or which would fit best for big foot. i dont know if you...
RCD makes two different keyed hemi crank hubs. which one do you have and what would be the cost to 96007? is it the long or short one?...
looking for zoomies for my fed, stock hemi head pattern. hopefully have egt bungs. using edlebrock victor jr hemi head - stock pattern im pretty...
rocky mountain tracking has nice inexpensive unit. its an on-demand unit. it uses cell towers to locate. its all setup in their system.
cant read/see the dash when your going down that track. all i care about is shift light and oil light. ill have oil pressure on motor to see as...
i have a front engine dragster. where would be optimum place to install the g-meter sensor or would it matter? i have my logger dash in front of...
as a note, the motor plate is drilled for both 426 and BBC. maybe a way to use the plate and use the BBC housing and not have to buy another housing?
have a new FED, at the time it was being built i didnt know if we were going to run BBC, 392, or 426 if that matters. anyways, we are running a...