Search Results

Search Again
  1. comp altered 632
    Post

    afr how

    If you need to check o2 / plugs early on run then just shut off early. How do you think a team tunes for 1/8 mile.
    Post by: comp altered 632, Aug 7, 2020 in forum: PSI Superchargers Tech Questions
  2. comp altered 632
    Post

    Clutch vs. Converter

    I have always ran a clutch. Ram 2 disc 8 inch.bronze floaters. Liberty 5 speed. 125 inch solid altered . BBC 632 NA..COMP A/A 6.9@ 192 My crew...
    Post by: comp altered 632, Jan 22, 2020 in forum: PSI Superchargers Tech Questions
  3. comp altered 632
    Post

    Kingpin degree for a dragster and funnycar

    Akerman is dangerous on a drag racing vehicle. I use no akerman therefore as the back of the car steps out and you put steering in the front...
    Post by: comp altered 632, Jan 22, 2020 in forum: PSI Superchargers Tech Questions
  4. comp altered 632
    Post

    parachute quickness/ finishline activation/engine braking

    I see this kind of thing at the top end as the air going over the car lifting it off the ground as a wing would ,then the wind gets under it and...
    Post by: comp altered 632, Jan 22, 2020 in forum: PSI Superchargers Tech Questions
  5. comp altered 632
    Post

    Weight front / rear

    Too many variables. Not enough info about racecar.
    Post by: comp altered 632, Jan 7, 2020 in forum: PSI Superchargers Tech Questions
  6. comp altered 632
    Post

    launch timing retard method

    If you got grid then launch retard is timed from launch input.
    Post by: comp altered 632, Sep 14, 2019 in forum: PSI Superchargers Tech Questions
  7. comp altered 632
    Post

    Clutched automatic

    Search this on bangshift
    Post by: comp altered 632, Jul 3, 2019 in forum: PSI Superchargers Tech Questions
  8. comp altered 632
    Post

    Clutched automatic

    Carnage Photos To The Extreme: A 727 ClutchFlite Transmission That Explodes EVERYTHING!
    Post by: comp altered 632, Jul 3, 2019 in forum: PSI Superchargers Tech Questions
  9. comp altered 632
    Post

    Clutched automatic

    An arrangement that drives the oil pump in the box by the fingers /levers on the clutch. fingers / blades from this protrude around the...
    Post by: comp altered 632, Jul 3, 2019 in forum: PSI Superchargers Tech Questions
  10. comp altered 632
    Post

    Clutched automatic

    Look at nostalgia pro stock.
    Post by: comp altered 632, Jul 3, 2019 in forum: PSI Superchargers Tech Questions
  11. comp altered 632
    Post

    g meter sensor placement

    Lateral g is also good for telling what the tyres are doing shake etc.
    Post by: comp altered 632, Jun 15, 2019 in forum: PSI Superchargers Tech Questions
  12. comp altered 632
    Thread

    Peterson oil filter location

    I have just seen the oil filter on a blown hemi promod fitted between the oil pump and the dry sump tank . What do you guys think of this setup...
    Thread by: comp altered 632, Jun 14, 2019, 0 replies, in forum: PSI Superchargers Tech Questions
  13. comp altered 632
    Post

    Ford 9inch

    Does the 10 inch gear need a different spool to put it in a 9 inch ultra case
    Post by: comp altered 632, Jun 14, 2019 in forum: PSI Superchargers Tech Questions
  14. comp altered 632
    Post

    Fiberglass bodywork

    I had to modify my 27 t body. cut up body . Fit the body parts where you want them then fill the gaps with flexible sheet material. Finish with...
    Post by: comp altered 632, Nov 16, 2017 in forum: PSI Superchargers Tech Questions
  15. comp altered 632
    Post

    Power Grid timing curve on blown Hemi Pro Mod, shifted, 2 disk clutch

    When taking timing out i take it out without ramp .but start putting / ramping it back in instantly with no time delay .this makes for a...
    Post by: comp altered 632, Nov 14, 2017 in forum: PSI Superchargers Tech Questions
  16. comp altered 632
    Post

    Power Grid timing curve on blown Hemi Pro Mod, shifted, 2 disk clutch

    Are you timing the points on the run from the driveshaft starting to move or clutch switch release ( launch on power grid) ?
    Post by: comp altered 632, Nov 14, 2017 in forum: PSI Superchargers Tech Questions
  17. comp altered 632
    Post

    Clutch vs. Converter

    DAVE. IF THEY SAY IT CAN'T BE DONE THEN GO FOR IT.
    Post by: comp altered 632, Jan 12, 2016 in forum: PSI Superchargers Tech Questions
  18. comp altered 632
    Post

    Clutch vs. Converter

    Or you could struggle for years with a clutch then find out you had fueling problems. My advise is buy O2 sensors
    Post by: comp altered 632, Jan 9, 2016 in forum: PSI Superchargers Tech Questions
  19. comp altered 632
    Post

    Front Motor Plate

    I like the sound of a carbon motor plate .is this just an outlaw part .or sfi. Any info would be good thanks guys
    Post by: comp altered 632, Jan 9, 2016 in forum: PSI Superchargers Tech Questions
  20. comp altered 632
    Post

    Kingpin degree for a dragster and funnycar

    I use 12 degree caster .and 1/8 inch toe in measured at widest part of tyre,this makes toe zero as wind stresses a-arms on run. akerman you don't...
    Post by: comp altered 632, Jan 8, 2016 in forum: PSI Superchargers Tech Questions
Showing results 1 to 20 of 20
Search Again