Separate names with a comma.
A lot of issues with raw material that have surfaced over the past year. Use caution, what used to work (torque cycles, runs, etc) may not work...
Wouldn’t expect much on the website. Jeff closed the doors on the business last month.
The noise could be caused by a number of things. Make sure your ignition wiring is shielded, you have good grounds, etc. It’s usually the simple...
If you set blade gap to .010-.012 and leak the BV to 80-82% that will get you close. If oil pressure, EGTs and head temp are all acceptable I...
I switched from 14mm to 8mm a few years ago and haven’t looked back. Does a lot less damage when it breaks.
More difficult to break a 14, yes. But it’ll do twice the damage when it does. You can run an 8 loose if you’re not detonating.
Hey Robert I’ll call you Monday! Mike
Need a set of dragster zoomies for BAE 8 heads w/EGTs preferably on the top. Let me know what you have, thx. Mike makracing3829@yahoo.com
What was the reasoning behind taking the washers off?
Star
At the end of the day, GPM/leakdown/blade gap/etc, etc, etc. doesn’t matter. Get it to idle right and then take those readings as initial setup so...
Put V’s in and check. I tried M’s once with similar result. Now only use an M on the thrust.
Will, rollout has been within 3/8” of each other, no change there. The limiters are set identical at 1/4”. I’m thinking one may be binding but...
Thanks for the great feedback guys. Tightened up the front limiters a touch and seemed to help, .940 60’. But now the car is wanting to go hard...
Yes. We monitor and adjust for track conditions. I have thought about adding some to keep the tire from squatting so much, but don’t want to slow...
Agreed. In all reality, I am pushing the limits on this chassis. It was built to run 6.0’s with a nitrous motor, definitely not what we’re doing...
Thanks Will. Definitely agree on track condition dependent. I’m just trying to understand what the variable is so Q1 isn’t a guessing game. I’ve...
Like Chris stated, pulling the covers is the easiest way to tell if something isn’t right. For example, lost high gear last weekend at the shift...
Figured I’d bring this thread back to life in hopes for some education on slip joints. BLUF: tighten them or run them loose? Spitzer 272”, blown...
Yes sir, rockers have oilers. Some push rods have them some don’t. I’ve run Trend tool steel push rods that have oiler holes and I’ve run Manton...