Separate names with a comma.
Just wondering which method everyone uses when degreeing in a cam. I have always measured 050 both sides of peak lift and was happy with that but...
Hi Will What will you take for the clutch with the scalloped (solid) flywheel?? And thickness of discs and floaters please Russ
Does this clutch have the lightened flywheel ?? (scalloped out back?) Thanks Russ
I've been watching #5 take a beating on my hemi for a while now and figured it might be time to try a shorter rod... I figure it could really...
Hi Mike I have had the same experience as B. Doucet. There is no rpm curve - no launch curve - just a time curve. But I think the key is...
Yep, that's a good point ...I was nearly caught out on that one but why does it show a different base timing when it hasnt been triggered? And...
G'day Propinny Nice to hear you will be at the Winters re-run. If you have time, the convertor change will give you the best result. I...
G'day Propinny A bit more info might get you what you need .... Is this an Outlaw Sedan with a four link or Ladder bar rear? And you...
Hi Mike Yep, this is the box that the EGT probes connect into. I was planning to mount the box on the headers because the EGTs are hard...
Hi All I'm just getting busy fitting up a new data logger and I've made some nice EGT box brackets to mount them on the headers but how much...
Thanks for that Justin. So just to confirm - there is NO organics / asbestos in the discs? Cheers Russ
Hi All I was looking at some 10" clutch plates the other day and started wondering what they are made of. I've heard a few people use the...
Maybe this will help a little. This is what you might hear at an Aussie race track. (translation in brackets) Reporter runs over to the...
Sorry Boys, it's not skivies OR KNICKERS - It's JOCKS (girls wear knickers - boys wear jocks) now that should confuse you :-)
Hi All While doing some routine maintenance I noticed that my valve springs are curved when not fitted to the head. It's not a lot, maybe...
Hey Mike Is that back to front? Too loose extension smashes the tire into the track Too tight extension makes the tire spin Or have I...
Hi All On a ProMag 44. What makes the "noise"? - The generator or the coil? Are they better close together or further apart ? (factory...
OK Yes it's a big cap deal. I'm working on 28* base timing and pulling 15* retard and I agree with the advice on setting the phasing to half...
Hi All Just busy setting up a new ignition system - Promag 44. I plan to run a crank trigger with six shooter and was thinking about...
i'm swapping ratio's in my Strange Top loader from 4.29 (9") to 4.56 (9.5")and a buddy tells me that the pinion bearing needs to be ground to...