Separate names with a comma.
Managed to bend an exhaust valve last weekend and I'm having trouble tracking down the cause. The damage I have is a bent valve, a lift with...
So the base ring should be flush with the chamber or the first thread?
The heads are undamaged the only reason I found out the plugs were protruding differently was because I was CCing them to get a accurate CR. So...
sparkplug protrusion How far should sparkplugs protrude into the combustion chamber? I have some that are almost exposing the first thread and...
Thanks Mike thats what I'm after. Emailing you now. Thanks again, Brad
Mike, I was reading this forum (http://www.insidetopalcohol.com/showthread.php?t=27258&highlight=high+speed) and was wondering where you get the...
Does anybody know have a main bypass pill drill size chart they would like to send me or know where I can find one? Regards, Brad
Thanks guy, I had thought of using DEVCON but wasn't to sure if the heat coming through the exhaust port would effect its durablity. The Moroso...
Hi all, I need to fill a couple of holes (EGR) in exhaust ports on a cast iron heads anybody got any ideas what I can use either an epoxy or...
I'm a bracket racer not looking for a full data recording system but need something to monitor egt's. Has anyone tried the Altronics Redalert...
Is 200psi cold cranking pressure to much for a blown 355ci small block with about 10lbs of boost?
Hi all, I have just brought a System One filter with remote mount and oil pump adapter, what size lines should I be using? Brad
I changed from a Bird Injector (hat nozzles only and square barrle valve) to a Gerardot Mag Injector (K barrel valve, hat and port nozzles) and...
Port nozzle pressure Thanks Mike, I thought it may have had something to do with that.
Port nozzle pressure What is the purpose of running a poppet in the port nozzle side of the system?
Oops, so I have to disconnect the lines to the hat and port nozzels and leav them open or block them off?
So when I leak down the BV should air be coming out the port nozzels if the pressure is so low? Because on mine it doesn't.
At what pressure do port nozzle typically come in at? And how would you determine what pressure they are coming in at?
Thanks mate I appreciate your reply. I bought my hat second hand and the spot that looks like it was used for the gauge is in the line that...
Where do you plum the fuel pressue gauge from? I have a K-style BV with hat and pot nozzels and a Hi speed.