Separate names with a comma.
lenco air shifted?
is transmission hooked up?
the c blower is different.not even close
I did try 32 in adrl race in la way back. those same heads. on suggestion of brad and his son in law because looking at my racepack they saw...
26 to 28 always worked the best for my veney motors with screws.'32' well the parts people loved to give free advise. low gear lean outs always...
take a look at your shocks
need your e mail and i will send some pics, bennie
use the read me section print it off. self explaning. pdf. 10 /15 pages.
it will not need to be fed oil. ex rockers will be ok with no oil fed to em. i just pre oil before you start.
around 6.935 dependig on compression you want with a screw veney , u need to cc and use a formula. up or down with rod length to get compress u need,
northern hydraulics.chinese but have built several sets and they held up fine
with a seal in pump ext i tfx 14mm have went with 51 tooth on bottom.i did hve 53 try to call you left message
r&r blown apex they also have onsite support and they pay contingency to our type racing. but they all break when in unhappy motor,but grps have...
well they can make your car go across scales with out trouble from officals if they weigh right?
well if all fails give up and go to state fair. mike the flaming river give me the fits. just like the pilot that was tapping on the gauge and...
with a c 3 lbs 125od but with a newer model mabye more. @9200
well took the day off.mike this is bennie. 48 volt starter.but had all plugs in engine except no 1, new engine . spun rear main at rock. trying to...
any ideas on a no spark when you hook up crank trigger on 44 msd 7531 with a lehey on one side and a msd trigger on the other ? neither will spark...
what is the diameter or biggest jet that you should use with a nc air leanout? or who might know?
50 lbs 4500 2 step c psi