Separate names with a comma.
My new car came with a 8117 prewired. can I connect the two orange wires to the + - of the coil?
A pedal stop is a big no-no on a blown & injected motor. You create an extremely lean condition because the barrel valve never opens all the way....
I have a couple of lenco bottles and want to use one for the lenco. all works fine. I want to use the other for the air throttle. both the bottle...
How hard are they to turn. tried to turn mine to phase rotor and it seams very hard to turn
any one know how to tell the differance between gas and alcohol.
I fitted the over center bracket today and as soon as i tightened it up enough to stop the bracket from turning the shut-off bound up!!!!. any...
My racepac pro1 has fuel pressure fitting can I run fuel to this port or should it be isolated? where should this presure be measured , pump...
What depth / width do you cut for 1/8 5/32(4mm) and 3/16 o-rings when doing manifolds for between manifold and setback plate / blower?
All, In the instructions it said to use 80-100 PSI As I run a CS1 Lenco I have 150PSI - CAn I run this to the throttle or should I get a...
I see a lot of teams useing a gold coloured y fitting after teh flow meter. Any idea who makes it and where i can get one. -10 to 2*-8
BBC 14/71 60* delta opening (not front discharge). Summer bros front mag drive. Due to new car I have some options available to do this...
On the Front fount drive should you run an oil line to it or is "splash" from the gear drive enough. Have seen both and ours is not drilled for it.
Ok. 540 - 2000hp 14/71 big & Ugly I have the following ratios 1.5616 & 1.4383 Makes 2.246 first What should be second ratio 1.56 or 1.44
Thanks all who have helped me get to here. (see old posts) I have started to change the Lenco from a 4 speed back to a 3 speed. 1.5616 ratio...
What tools are needed to do a clutch Dial indicator weights kit scales what else is required Tyson.
Gents, (havn't seen a lady here so appoligies if there is) Thanks for you previous help re- clutch and lenco I have spoke to lenco and they...
All, I know if you go new the manufacture will advise. but in general, how do you know what your looking for? 3000lb ish door car 540bbc...
All, Long time reader, Mag selection, I'm wondering what I should use Like MSD for the pointsless and other aids should I go with the...
