Separate names with a comma.
Just got my Electrimotion 15 channel Time Mod, and 10 stage Air log + Power Module. Does everyone have their stuff mounted on the CF tray In...
Does anyone use or know someone who uses or used The T&D rockers for the Brad -5 head? Any advantages or disavantges compared to BRAD"s rockers?...
Is there a site I can go to for tire numbers etc. Want all info on 36" Fuel tire. Is that the same as you would run a 36 " tire on a Alky car?...
I am sure this was asked before, but i looked and can't seem to find it. How much of a change is it when you go up or down for every .010 of...
What do you think the Pro Mod guy's run for comp or cranking pressure with the 20 overdrive limit. I know they run the big bore stuff. Thanks Don
Don,t have a set of single plug valve covers to check with, but need to know witch hole do I install the plug ? should I still use a touch of...
When only going to run a single spark plug, witch one do I plug. I see Wizzards has plugs for the head, but I don;t see anything for the Valve...
BAE Hemi Superman supercharger 296 " dragster. Will a set of ATI 1.66 first gear work good. Had one before, made less HP, had a 176 gear with 389...
What is the distance from bottom of supercharger to center of drive? Buel print doesn't show me this Thanks Don
Need some help Need to mount a starter on my mid plate . KB -10 block Reid powerglide bell adap. Have a reactor flexplate .No room for chevy...
Looking for a size on a rear wing for a Top dragster. My TAD 64 x 16 is too big. What are you guys running. Blower car Looking for 6.50, 200 +...
Back again Does anyone know, or knows someone who could figure out if you could successfully run a injected hemi on alky, with a crower glide...
Does anyone want to give up some information? Thanks. What gear rato in a blown top dragster with a lenco drive. do most guys run ? If its around...
Do they make 320 gears with 40 spline pinion ? Or just 35 spline Thanks Don
wondering the OAL of a power glide and the length from block side of bellhousing to output shaft of a lenco drive 2 speed. Thanks Don
Trying to find were I can buy some 1.3/4 alum fuel line. We are on the east coast. Trying to stay away from Murf, etc. Need 2 45 and 1 90 degree...
Does anyone have any reccom. numbers for the interfearance fit for a Tit. crank hub and crank snout. I have .005 now. Ati says .0007 /.0009. That...
putting out some feelers for 09 season, maybe end 0f 08. Looking for someone for Div. 1 This is a new car. No seat kickers. If you have exp. You...
What would be the ring gap for a top tool steel dykes ring for a inj. nitro motor..4.375 bore . .018 ?? Thanks Don
KB stage 10 block. Do we torque, the studs first and then the side bolts, or should I alternate as I torque the studs. Any ideas. never did...
