Separate names with a comma.
Good Afternoon. I have what was described to me when I first purchased it is a Newbery/Veney combination motor with Venolia pistons. At one point...
I have a KB Stage 3 block that had some main journal repair. Unfortunately they cut the block leaving the caps at full height. This has created...
Does anyone know if a spline'd crank hub for a front bearing crank support exist? I have a Front bearing type support but just switched to a...
Good Morning, I am a fast bracket/sportsman racer (4.70 1/8 mi stuff) My engine is a 526 old school blown alc Hemi KB stage 3 block (water...
Whats are you using for a timing light? Looking for a self powered unit. I have been using my tried and true light that requires a battery hook up...
Did MGP rods get out of the Blown Alc rod buiness? just went to their web page and they only list Chevy, Ford and import rods.
Hello All Recently I have broken two belts back-to-back. First one we figured was lean condition issue since we had just made some fuel...
Anyone know where I can get a fitting like this 10AN to -8 ORB
What do we think about Lucas 70 wgt oil? Anyone using it ?
This issue just arose. As the RPM increases my oil pressure drops. I hadn't noticed this until this past weekend. But it follows a recent oil...
I've seen the 5/16 hex on a HEMI pump drive break more than once but for the first time for me I broke the Mag drive slot (not the mag base) in...
Hello all Is there anyone out there running Alkypro and Altronics Performeaire PC based weather station. Just acquired both and cant get Alkypro...
Question for all you that maintain you own blowers. I just went through mine (first time) and the only concern I have is what sealant are those of...
Hello all I have a KB cast oil pump that is burring my 100psi pressure gauge...I pulled off the Large Hex Cap on the lower cover expecting to...
What do you think the best (cost,quality,usability,dependability) Radio set is? Looking for a 2 radio set (driver/Crew) and dont want to spend...
