Separate names with a comma.
If I remember correctly it has to do with the position of the converter snout to holes inside the Bruno unit. And yes if the clearance is too...
So on the Gorr Dual Circuit BV what is the setup. What do you set the idle return at
Forgot. Check the poppets for sidewall scoring and freedom of movement. They should not leak when below the crack pressure.
Did you also buy some pressure adjustment shims. When I say 8 1/2 to 9 1/2 that is crack pressure. I would check all the check valves and see...
That will probably be the problem then.
No general rule other than previous knowledge.
TOL normally one aligns the front crankshaft bolt to the rear end of the transmission to the pinion to ring gear mesh point. There should never be...
Nope, don’t believe I said that raising will lean it out. If you increase the idle check spring pressure you will raise the fuel pressure at idle...
Oops, just read your question again. The answer is no. If you raise the idle pressure then you will have to reduce the percentage of BV leakdown...
You pretty well hit it right on. The norm is 8.5 to 9.5 with 82% leak down. The percent leakdown will put you in the correct area but then you...
Has it always been low?
To micro weld means there is movement in the hub. I would get a new RCD crank bolt and put the 280 to 300 ft lbs of torque on it. In the future...
Can you also lower the pressure? If that is the pressure at 3000 rpm then it is going to be real soft on launch. The lowest you should turn it...
It can be on either side. Your choice.
By your description I would say all is normal. If the valves tulip or turn blue then you are lean.
I would highly recommmend selling that blower and getting a good used Littlefield LB20 or a Kobelco Superman. You will make really great boost at...
If you send your can into Trick Ti for re-cert then they will automatically update it and you will have to get a new flexplate
Try Mike Riechers of R&R Rods in Punta Gorda (941) 621-8143. Just talked to him and he said he can do it.
Call Daryl Hameetman of HRE in Cape Coral. (239) 673.8627. Tell him I told you to call him. If he can’t then maybe he knows somebody that can. I...
Where are you located?
