Separate names with a comma.
Has anyone had any luck finding a decent, affordable, engine simulation software program that plays reasonably well with supercharged alcohol...
Hey thanks for that Tom, I'll read it in more detail tonight. The 30K thing came up during a conversation with Roger Olander a few years back....
I saw Will's comment about 2.28 ratio earlier and to be honest I'm not familiar with the origin of that SFI spec or whether it actually even...
So I'm curious now...... What is the theoretical max HP potential of a "C" on a typical alcohol screw V8 with no rules in the way? Maybe a...
They are better than the PSI? Will have the DMPE absorber too.
In this case my upper is a 37 tooth (could even be bigger if I wanted) and the fuel pump does not drive off the cam centerline so no lower...
What's the highest O/D that anyone has tried with a C or D, and what sort of max compressor shaft RPM did that turn out to be? How much RPM can...
So you are saying that you prefer Z-Gap versus appropriately set up "normal" gap rings? I'd be very curious to hear more on this. Thanks.
Has anyone tried extending the snout of a PSI screw (C or D with billet cover) by an appreciable amount like people do in the roots supercharger...
Some photos would be great. Thanks. whome@look.ca
I've heard only thru rumour that PSI has a 1-3/8 offset kit for the mini snout. Is this correct? I might be able to use that, or at least use it...
Have a PSI mini snout at the moment. Could change. In a perfect world I'd like 2 inches more. In less than perfect world I could live with say...
Let's say a person wanted to extend the length of a PSI screw blower snout, forward further away from the case leaving the case where it is, what...
What sprags are in them?
Check you PM's....
Can anyone tell me what the actual internal compresion ratio is for the PSI-C? Thanks.
If a person has to run questionable tracks from time to time, would having an airthrottle deal be easier to work with, or is it best to just stick...
When you tear it down, pay close atention whether any of the other rod bolts are loose feeling. Are you using a stretch gage on the rod bolts? I...
Roughly, what is the weight difference and length difference bewtween a T400 and a 3-speed Bruno/CS2 ? How are the gear ratio selections for the...
Has anybody ventured down the road of trying a metal matrix composite (MMC) connecting rod in a blown alcohol deal? If you would prefer, PM me or...
