Separate names with a comma.
Make sure to have a residual valve in the rear brake line for sure with the large volume in the calipers....I have 2 lb in both front and rear...
Sprag in backwards - ask me how I know...
For the parachute cables - if they are close together where they go through the body as mine are you can use a spark plug wire plastic separator...
I don't wanna beat a dead horse but thought that I should mention again the confusion about the Anglia/Strange spindles....Strange does make a...
I ran 3" mains for 10 years and had a total of 4 blocks during that time (destroyed one but not due to main bearing size).....but the size of the...
Got stiffed for $7300 on several printing jobs....I have judgement against Ray but not getting very far on collecting...it's still active with an...
I tried a set of solid core plug wires one time with a points mag and got flames....actually burned a few holes in our carpet that we used as a...
This response is what I have learned from a few groups that issued their own rules for safety....not NHRA rules.... The fuel and oil lines are...
Not sure if you have found the problem on this by the recent posts....but I wanna tell a little story about a hot ignition system problem when I...
Hey Jim.....I think what you are looking for is a simple toggle switch....our launcher system came with an air operated toggle switch and we arm...
This is an "after everything else" scenario....very obscure problem that John Dunn had on his NFC a few years ago...probably would not be as...
My truck & trailer weigh just over 20,000 lbs. so I thought I was exempt from the CDL....wrong....if the truck & trailer CGVW is over 26,000 then...
OK - this is a very crude way to fix it but worked for me....I put a 502 crate motor in my 1969 Chevelle and swapped pans to fit the...
Pit Pal Box Better shot of the box....now I'm just showin' off! [IMG]
I had Larry at Pit Pal make a little computer box....was only $70 and made to my specs......
RCD Splined Crank Hub Installation With the double keyed crank hubs we used red Locktite on the hub and bolt....torqued to 350-400 ft....
I agree with John on a part as large as a rear wing.... I manufacture reproduction mouldings for 1960's Chevrolet cars...and before we started...
I measure them about every 10 passes....they are born with .003-.004" positive taper in the skirts...so the bottom is just a little bigger than...
Josh - I always wondered why there was not a fix for this! I'm a little bit of a clean freak and don't like all of the oil either... One issue is...
Not that it answers your question, but we have a Lencodrive...a few years ago we had the trans out for service and also had a local display...
