Separate names with a comma.
I had a Johnson split pan on my SBC loved being able to check rods and all but the rear main. Can not recommend it enough
I did 3.3 in a 2650 lb in a super chevy nitro coupe still had close to 3 to the top of first gear
I have a few ideas i would like to try including .083 wall tube for the first 4-6'' maybe 4130 flanges different bracing.... looking for a Ginny...
Helping a friend re strip a older littlefield 14-71 typical older blower half the screws are stripped that hold the strips.so There are nuts...
msd had a prototype 66 amp mag it got nixed by the NHRA tech dept before anyone ran it would it work on a max effort PX pro mod car with all of...
mfi pull the fuel shut off slighty closed EFI make a warm up fuel map
I keep mine fairly locked up i have drove thru the clutch a few times it has not effected the TMT just have the common heat checks.TMT is a...
they are magnetic so i can use a surface grinder or let them rest on the steel platform on my clutch grinder it was on a 2400 hp turbo SBC...
They are great if your not slipping the clutch a lot to get the car to go down the track. When i grind them after 4-5 runs it takes about...
Had them zip tied on the few top fuel cars i worked on wires get ohm every few runs too..
On the small block always put the o rings in the block receiver groves in the head makes welding on the heads easy don't have to remove o rings to...
I would get the injectors tested or check wiring on those 2 cyl the only time i have had egt spikes like you had is when a injector stock closed...
I run 45 lbs @9500 with a sbc steel ext valves 375 on seat its a turbo motor cam was 840 lift never had a lot of issues.lol remember years and...
i ran the same set up years ago 8.050 hat nozzles hilborn -1 pump mine was a 355 brodix -11 heads standard littlefield 6-71 pill was .040 to .080...
30 lbs on a 5 speed gear sets are lighter
Where and when ??? my question if a can can not contain a ring gear how is the rest of the can going to hold up if a 3 disk clutch explodes...
looks like his gears are billet and expensive i like going to orilly's and getting one for 28 bucks lol
mine rubbed a little had 4'' clearance @215 mph
lol and doing it old school you get to surprise the guy in the other lane.I was at Tulsa and Scott Palmer was driving a friends screw blown clutch...
I just made a comment that...........doing it the old school way which is hard for for some to do i still had 20 psi @ .08 and 30 .2.this was...
