Separate names with a comma.
Mike, I have been reading this thread with interest and have 1 question about a statement you made regarding the 115lb springs. You mentioned...
I went with the longer rod strickly to reduce the side loading on the piston as much as I could.I don't really think it will build any extra...
I went 6.70" with mine. The pin buttons are in the oil ring but plenty of room. Lots of piston dome thickness. Arias pistons and GRP rods....
Done! Thanks Guys
This may be a dumb question but I've never delt with flow meters before. It came with copper rings around the fitting ends, are these for...
2.60 1st in a 3 spd? No expert but isn't that a little to steep? I would think a 2.05 -2.10 maybe. At least from what the experienced guys have...
The only thing I can suggest is trying to let it cool slower, do a good pre heat and after welding wrap it up or use a torch to try and hold some...
Thats pretty much the same as the fan I am looking at, they are blowing them out the door at $49.95. Just wasn't sure if the small one would do...
I am looking at blowers for a clutch cooling rig, I can get either a 1200cfm unit (pretty noisey) or a 300cfm unit (pretty quiet). My question is...
Has anybody tried a spray made by MG chemicals for EMI suppression when running dataloggers? I know this has been kicked to death surrounding the...
I use King bearings and I really like them. They come in .001 under and .001 over sizes which is nice if you like to get you clearances exactly...
Thank You:D I didn't want to be the first person to ask that. I have a cam on a 116LSA (chevy) and thats huge. When I saw 117deg, I just figured...
No Cam expert but what is your lobe sep deg right now?
I use this heater: http://www.moroso.com/catalog/categorydisplay.asp?CatCode=15013 As far as the guage, its an older Procomp liquid filled...
I have pretty much tried every external method to heat oil in a pan, the stick on pads don't stay on, the hot plate idea will cook oil if left...
At what point should a person consider using a spacer to adapt a hat to a blower opening? My blower has a 10.875" opening and the hat I have has a...
What size pushrods do you have? Manton pushrods are hard to bend;)
Ripped the head apart? Wow. Seems anything is possible after reading that.
Could have been coil binding also.
I just re-read everything and you said the lifter end smashed the bores,crank,rods and pistons? I'm thinking possible piston to valve now...
