Separate names with a comma.
I am currently running a powerglide behind a blown alcohol 540 making around 1500 hp, just purchased a 526 new century and going to be moving...
I use esso hydraul 50 oil same thing with the smell
We run a 3.89 rear gear with a 1.69 low in a 2600lb door car making around 1500 hp runs low 7's @194 works well.To give some more detail our tire...
looking into it a little further i will match the pressure and flow a transmission flush machine uses as it circulates fluid in the same way...
I am building a portable remote oil cooler for my powerglide any idea what pump pressure i would need to circulate fluid efficiently through the...
I agree Ryan at 1320 Media is the place to go
We use the paper filters you use for painting they have a very fine screen, and fit nicely in a funnel
Any thoughts on running the Taylor thunder volt 50 series wires with a mallory sm iv.on a blown 540 bbc we want to run with a data logger so i...
i talked to rpm and got the same info you gave Corey thanks i was just curious who may have run into issues and if there was a chance of it...
Has anyone successfully used a Mallory mag iv and a rpm data logger in a door car? with a tach adapter as opposed to the crank pickup that is...
Sorry to hi jack the first thread on this topic but i am very interested in this info as i have a similar set up 2600# door car blown 540, 168 1st...
where the work was done is very hard to notice could polish up a bit better but no scratch or gouges and were done off to the sides at about 10 o...
I spoke with Brian at GRP he said they wouldn't do it in house but has seen and heard of it and doesn't feel it will be a problem as he has never...
Any thoughts on the max amount of material removed to balance rods on the small end with a 1.094 pin. he reason i ask is we have a set of GRP 5000...
Thanks for the input, so if i understand correctly, I should go to a good carbon core wire that has a straight through core and buy the set that...
What is the spark plug wire of choice if using a super mag iv on a blown alcohol motor, and if it matters there will be a RPM data logger.I was...
has any one looked into or used a series-parallel switch? it gives you the 24 volt start and has a 12 v circut similar to csr's magic box but just...
What is the best choice of belt/pulley to use and why. 8mm,13.9mm etc? i have a bbc 540ci with a rcd idler and was going to run 8mm belt and...
Hey Don i am just finishing my motor which is almost the same as yours Dart block 540 aluminum rod 1471 and i am aiming for 1500hp so once we dyno...
Ok so i have decided to not to run a cooling system thanks to all the advice given. But my question now is should i fill my block if so to where...
