Separate names with a comma.
Mallory Mag I talked to Spud @ FIE about what wires to use with the SMV he finished for me and he said that the MSD wires will work fine. It...
Mag Just refering to the Mag itself and what steps are needed to guard against EMI. I am running MSD superconductors to cut down on...
Bearing Issues I'm just trying to picture what you are discribing. Those bearings must be twisting to the extreme if the tangs are staying...
Block problem What is happening to the tangs on the bearing when it walks? Are they breaking off or bending? Corey
Shielding Thanks for the info, the three ft you mentioned was great. I was going to ask that, my firewall is aluminum (door car) and I have a...
Just received my RPM data logger from Randy and he suggests with a Mallory mag to put the computer portion of the logger in a project box or...
Oil Issue I have no experience with Hemi engines but if you hit the chutes and loose oil pressure sounds like you are plastering the oil in the...
Idle Check I was thinking about it after I asked the question and it seemed to me that what you just said was exactly right Mike, it always was...
I was going through my notes from my fuel system and I noticed among other things that when I got the system new it came with a 16psi idle check...
Sensor placment Thanks again Mike that makes thing crystal clear. Corey
Just beginning my research on the best way to install my datalogger (RPM System). What is the best placement for fuel pressure & flow meter? I...
MAg Interesting Mike, do you know if this happens with all mallory mags,regardless of the output? Corey
Mallory Mag I won't comment on the ignition retard concept that Mike stated, he has infinitely more experience than me and its probably true. I...
Head WANNABE: You mention a .080" gasket is hurting performance. Could you explain this further? I run a very similar thickness gasket in my...
Start Up When I ran a wet block and heads (Chevy) it would take quite a while at an idle to even feel any heat in the heads at least 10-15 min or...
Re-Torque I do it. I never prefer to rush through things, I've screwed up enough stuff rushing. With the water I would think it would be even...
Discs Do you do floaters as well on the lathe, or just the discs? This sounds interesting, I may look at doing something like your setup....
Heads X2 on the Dart 360's plenty of flow potential, plus you can get them solid if needed. Corey
Caps We were running low 8's @ around 165MPH but we had lots of tuning, car was right around the 3000lb mark with a dual disc clutch and...
Main Caps I used to run a Merlin III block (similar to the Bowtie IMO) and I ran with just the cast straight caps with no real problems. We ran...
