Separate names with a comma.
brt Not fixed, we lost another round because of it. Put a line lock on the front brakes and a 9qt oil pan for ADRL Topeka this weekend.
I have a K9 superman 1471 with mods for IHRA funnycar high OD. I'm currently at 37% and would like to go to 40%.How much more fuel should I add. I...
bruno Doesn't sound good...The harder/hotter they run the more they seem to puke.We removed the poppet on the return to the pan per Marty and it...
I've been talked into an RPM unit by numerous people. Anybody have a used one for blower promod? Thanks Mike 316-259-3883.
bruno We inspected the drum and band closely. The drum still has the factory machined finish on it. The car creeps slowly. So slow that it won't...
bruno To make matters worse the problem is intermittent. I took all the air piston and solenoids apart and found nothing wrong.We fired the car...
I've been fighting the brake in my bruno behind a blown promod. It failed at 4100rpm on a air throttle. After tearing the unit apart and finding...
Any pics of the blower bag? Mike MICAH72L@hotmail.com
Thanks for all the replies. The plan is to raise the co2 pressure to 250psi install a bigger/deeper oil pan and launch with the 2 step in...
I know this topic has been covered but i'm looking for any ideas I can get. We have a 2900lb roots wedge promod launching at 4100rpm on an air...
I think it depends mostly on your blower. We run a big chief 540 with a K9 1471 made for high overdrive. Going from 32-37% picked up 8mph on a...
We want to ditch the big 12volt batteries and use a single 24V external pack to start the car with the block mounted starter. Maybe use a little...
I've used the 7531 on promag12 and 44. It works good, just follow the instructions for the mag configuration..I think it's better than the 8973....
We broke ours in 3 passes. Car can only idle in reverse.Lenco makes a billet straight cut planet. It's over 600.00. We're going to idle the engine...
We have run a setup like yours for 3 yrs with a glide and have a few passes with the bruno. You have lots of good stuff but 7500rpm will not work....
We just switched from a glide to a Lenco/Bruno 3 spd in a roots blown promod. The car smoked and shook at the 1-2 shift on a marginal track. I'm...
Danny, did you ever get that Quikdata turd to work? We had similair problems and are trying to come up with a plan before the season gets here....
I'm looking for a lenco 3spd to run behind a Bruno drive in a 2900lb promod. Lenco claims the old coarse spline CS-1 stuff is good for 1800hp. I...
Mudwrench, Jesel quoted 1200.00 for one piece stands only..no rockers. I don't think anybody else has a one piece stand. PM me if you want pics of...
we run 60wt redline with solid 80-100 psi through the run. It was a weird high speed/rpm shake. Broke both wheelie bars without them touching the...
