Separate names with a comma.
I wonder how many of the Alan Johnson blocks are out there? I don't think there are many.Could Bob Miner say any distinguishing features between...
Hello Ben, No, but going to the div. race the next weekend. To let you and Jack know, I found some cracks in my mainwebs so we'll be done for a...
Are they going to run TAD & TAFC at the Las Vegas nationals this October? -Dale
I have a 526 Miner Bros. that I have to cam cut the Brooks rods in.I'm in Colorado also, If you'd like give me a call. Dale 970-302-1232
I don't think that the boost on the backside of the intake valve has much effect on valve float. It don't take much spring pressure to hold the...
On my Miner Bros. motor the head torque is 190. I have to go find a big strong kid to do it for me (LOL) -Dale:D
Randy,I'm not trying to sound smart, but don't you think even if 125% was still allowed that guys would still run the motor to the max rpm that...
.017 on the plugs,and .070 on the crank trigger. I watched a guy pickup .4 tenths changing the plup gap from .030 to .018 with a 20 MSD mag.Also...
I don't use gaskets or sealer. I adjust the butterflies to compensate for the small air leak that happens.Most hat nozzles have a air bleed in...
Can a guy use a MSD rev limiter chip in a Autometer shift light and work correctly ? They both plug in to each other.
I don't think it matters on tire shake, but we thought it might have more to do with the launch in that if the car did not back up after the...
We built a car with the M/W 9 in. modular rear with 40 spline axles, and there is considerable more backlash between the 2 wheels than a couple of...
I think you can get a bearing through Bonifontie that has a sleeve on it to fit the chev crank. Dale
3-D, Sounds to me that your setup is working pretty good. I wouldn't worry too much about the pump pressure,in that the fuel going through the...
Unless the person telling you what jet to use knows how much the gallonage the pump puts out and knows the nozzle area and knows how much boost...
I know it isn't the norm, but I put o-ring groove in the block-sleeve. I believe it to be more stable in the cast iron and less apt to work...
If you go with the M/W rear, get the 1 piece drive axle. I wish we would have.
Ditto on what Marty said! I've seen a couple engines ruined because of lash locks. Snaps the valve off right at the keeper groove.There is not a...
I guess one question would be-does he wan't to run a cooling system? Unless he wants to use a cast iron hemi block,and cast heads, there aren't to...
I have a 672 BB chev blower motor for sale. Makes tons of torque. Don't want alot for it either. 672 BBC Short Block Aluminum Merlin...
