Separate names with a comma.
Lifters I just went through this same problem about a month ago. I was going to go with the Isky redzone lifters as well but I was hearing some...
360 Head combo Have the heads had any port work done to them? 370 CFM seems a little low for a runner that size. Corey
Rod Bolts Paul: I was able to find the Ring Guages (for external threads) in all the various fits, but plug guages(internal threads) were only...
Pulleys Give JR a call @ RBS Superchargers, he has a pretty good selection a pulleys. He is also good with trading in pulleys if you have some to...
Threads Did a little more research and I found the plug guages only come in a 2B thread fit,( a least the ones I can get) which is what is...
Threads I found them , they call them a thread plug guage. I think I'm going to get one. Thanks again Corey
Rod Bolts Hey Mike: I like that idea of a go/no-go for rod bolts. I have never heard of one (not suprising). Sounds like it would be good to...
Nitro Question I just repaired a fuel tank off a friends nitro funnycar and it had 2- 2 1/2" outlets on it. His car is not cutting edge, its a...
Gasket Sealant I agree with MRK-588 if you have no water then a dry gasket will work. The only reason, in my opinion, you would put any sealant...
Gaskets What are you concerned about the oil,or the combustion pressure?
Lenco Reverse Problem This must be a Lenco drive problem because I haven't had to replace one thing in my CS1 reverser and I've had it for 6 yrs....
Oil in Canada I'm from Canada also and we can still get the Royal Purple SAE60 (nitro blend I think its called) depending where you are from...
O-ring Wire X2 on the crazy glue idea. Corey
Rubber or hard lines It is a blown alcohol top sportsman car. I think I am going to go with the rubber lines. It seems they will be easier to...
I have a question, whats better, the hard lines you get from Enderle or the rubber flex ones. Is it just a looks thing or are the rubber flex ones...
L-19 To be perfectly honest I didn't want to even call ARP on this or my rod builder (GRP) becasue they might think I was *ucked. Figured I...
Can anyone tell me if there is any special procedures involved when handling or installing rods with L-19 bolts in them. I am hearing all kinds of...
Poppet tester Eli, I was able to see how you built the poppet tester in the second picture but the little piece of braided line has me a little...
M5 What would switching from Pure methanol to the M5 do if you were running a program like Jetsize? Would would it make that program less...
I was thinking of running an air throttle, but I have heard some horror stories of people basically getting run down if the solenoid fails.:eek: I...
