Separate names with a comma.
Think I found my problem,I hope, seems my 10 plus is bad. Has power to the coil even when I turn off the 12 volts to the box. Won't fire the coil...
Everone, I'm sorry... should have stated that I run a MSD 10 Plus, ran all year with a MSD pickup set at .050 with no Problems. I run the sheilded...
had msd pickup on before, no problems, went with all rcd stuff to better fit the front crank support they recommended the Leahy pickup.
Went with an RCD front crank support on a big chevy. Used RCD crank hub/trigger wheel with the small 90 deg Leahy pickup. Left everything else the...
Ha Ha Glenn, nope.... we usually just hold a yellow dog yankee down to the asphalt and drag his rear down the road. Find it leaves two nice...
I put 44 runs on a set of MGP rods this year some 1/4 rest 1/8 mile. I run a 4 in. stroke and see only appox. 8800 rpms on top.
Maybe if you load about 100 lbs of paint in the car and then throw it out at the gear change you can pick up a couple of 100th's. :D:D:D
Frank, get you an ISP seat kit, form fitted and when finished it's covered with nomex.
Frank, try 864-338-9942. You'll have to try a couple of times to get him, semi-retired. try retarding your cam appox. 6 deg. A friend of mine had...
Do you have Hortons number? Maybe he can help. Turn it up!!!! No such thing as too much power. Should run 6.30's with no problem. I've been 6.17...
Tom, I run a crab cap on my blown chevy with big duke heads and msd 10 with no problems. Been 6.17 in the 1/4 and 3.99 in the 1/8. With my Indy...
Frank, what's up?!! How do you like my old FED? Horton said he saw it in Ca. this year. My blown RED would shake the tires all the time until I...
Tom, why can't you run it in the stock location on the rear of the block? Everyone I know that runs a 10 runs in the rear of the manifold, works...
My buddy Dave Harris from NC ran 6.18 in the 1/4 and 3.99 in the 1/8 with a iron dart block with ray franks 24deg heads in a dragster. Blower was...
Get one piece rocker stands from jesel, they are fairly new or weld yours together with small bits of Cm steel. This helps stabilize the...
Has anyone made any progress with A/F ratio meters on a blown alcohol motor lately? What is the correct A/F ratio anyway? There are now systems...
On my bbc with a retro high helix littlefield set back about the same on a indy intake, I ran nozzles as follows : 1-#76,2-#66, 3-#54, 4-#59,...
Relentless, check your PM's. Jody Stroud
I priced one last year, seems like it was almost 5000.00 bucks with the scoop.
Simpson Diamond Lite, I have a one piece sfi 20 and even it is very cool. I can feel the wind blowing through it, kind of heavy but not very...
