Separate names with a comma.
It is pretty routine on starting the motor doing a burnout backing up then staging. There are some things that can cause slight delays but not...
The only time Water Grains should have a bearing on the tuneup is if the Davenport software reads out that it is over a 100 grains. There is not...
Bob, a question here if you don't mind. How is it possible to be the ignition box? I wouldn't think that the ignition knows the difference between...
We used to use a Oberg filter and I always found evidence of embedded material in the bearings. Switched to a System 1 and they are a smooth as...
The 2.10 (1.45 & 1.45) are the ratios I was trying to remember in my earlier post that are most used by blown ProMods with a 4.56 rear gear in...
Do you know hat brand clutch can it is? Normally the only guys that will modify one and then certify it are the original makers of the can. Is it...
Call Matt at Lenco and ask him. (800) 854-2944
Lets hope I remember this correctly. You want it to read the percent down from being wide open. If it is a leakdown tester and you are putting in...
I was always under the impression that if you used a converter that you only used a two speed Lenco because the torque multiplication of the...
According to what Nick Bonifante Sr has told me the floater is installed correctly as far as the single style tabs being on the left side of the...
Hoosiers are the most common tires used on blown ProMods. Nobody I know has any problems with them. The is no peeling or chunking. Most if not all...
Yes, I would recommend removing the rocker arms or if you can take out just the pushrods. If you can't do any of that then turn the motor over to...
Is it the phot or does the clutch disk look like it is in backwards. Maybe it is just the type of disk being used. What do you guys think?
http://www.alanjohnson.com/ajpframe.htm Then select Cylinder heads then 481X billet alcohol
I am not sure of the settings for the 6 stand. i know on our 9 stand we use right up at 4 turns on base and around 80-85 grams total on all the...
Is that a RAM 6 finger of 9 finger clutch
At .5 seconds into the run the DS should be up around 2400-2600 rpm. I question the 1.80 1st gear with a 4.30 rear. it would seem like you need...
Yes that is just how we and other ProMods are doing it No problems yet.
Just a two step....nothing else.
I believe the Littlefield blowers with the K-9 rotors or early K-8 rotors had problems with the rotors cracking and comng apart.
