Separate names with a comma.
read this and you tell me what it means:: From: John@XXXXXXXX.net] Sent: Tuesday, October 17, 2006 9:20 PM To: Peaco, Skooter Subject: A/fc...
Congrats Mark sure hope it is not the last year for us...
what brand do you now run?? inquiring minds want to know...
Who all makes what in carbon Harry glass , Roush any one else? Who makes the Status
will be nice to see randy and pete running together again
we run Mike's rods also very nice piece I like his rod cap serrations not one problem yet and we was plenty hard on it getting this new combo...
sounds like it is running out of oil you do the burn out it all gets put up top by the time you stage it is getting back to the pan but only if...
good job Paul!!!
360 psi on the seat is ok for some applications we now run 425+ psi on intakes remember the boost and the size of the intake valve has a big...
does this mean i can buy from Ross or C &A or only from Bob I need to get 10 for the 2.6"
200 -191 =9% at least when i went to school unless your spinning this with the camshaft
i heard the spring nats are going to norwalk next year do you think they will run the alky cars there not sure there is enough room for all to...
Still No and Hell NO i will take away from us poor under funded cars trying to run You can never compete with the Kallita's and Bernsteins
NO and Hell NO would be like TAD and A/FD could never be equal we knew this was coming Saturday when we were there
the third session was the 14th pass on the new chassis/mtr/clutch combo so i guess the 5.97 was going in the "right" direction and thanks
Congrats Tim Even thou you kept us out of the show, i am glad you won it!
anybody running a setback blower having trouble streching the studs? Does any one make or use a brace to stop this?
baby powder sometimes will help if you dont sweat to much
drain both after the pass lots of oil gets trapped in the covers during a run we put 5 gals in our tank (gordy car)
last resort take one to some one that does laser cutting then have them parallel ground laser cutting is so precise you can tap a hole it cuts
