1-1/4" ID Hose For Alcohol?

Looking for options/sources for hose. I see that Good Vibrations has the Perosil hose. Also looking at what McMaster Carr has to offer. Any other options? Ideally I need something that will bend in a 2-1/2" radius without collapsing or kinking.......................

 

Mesa hose has some NHRA approved hose in 1-1/4 good for puke tanks, I have used it as fuel line in places but don't think I would trust it on a tight radius. I have also used some type of chemical suction hose from Briggs Rubber that had some wire in it. The wire was made into the hose, not exposed internally. If I remember correctly the stuff I used was 1-1/2, it's possible that they may have it in 1-1/4 also. You could always try and find a piece of radiator hose with wire in it and change it yearly as the alcohol will eat the rubber. Hope this helps.


http://www.briggsco.net/petroleum_hose.htm

 

what are you using for clamps? I'm trying to find the style with the wavy slider deal inside and can't seem to find them

 

Good Vibrations has these is that what you're looking for?

http://www.goodvibesracing.com/Braided_Stainless_Steel_Hose.htm#Purosil

 

I don't think so judging by the picture on that site.

Spitzer used them when they put the new fuel lines in my car so I just gave them a call. McKinney sells them apparently....

http://secure.mckinneycorp.com/newmkc/Items.aspx?code=TURBOCLAMP&key=cat

 

Contact mesahose for the silcone style hose, its a pain to get on but is the best sealing hose on the market, and the clamps sold by mckinney corp are the absolute best option.