Recent Activity

Kenny Laughlin posted a new thread.

FOR SALE: Noonan 600 Billet Heads

Noonan 600 Billet Heads (New) Springs Titanium Retainers – Low Runs $6,250 CONTACT KENNY@ 817-219-7957 OR KENNY@DRPIND.COM

Forum: Noonan Classifieds

Kenny Laughlin posted a new thread.

FOR SALE: 526 BAE / Noonan Screw Blower Motor

526 BAE / Noonan Screw Blower Motor 128% Over BAE Block Noonan Billet intake Screw Blower Bryant Crankshaft (New) P&P Wet Sump Oil Pump...

Forum: Noonan Classifieds

Kenny Laughlin posted a new thread.

FOR SALE: 526 BAE Screw Blower Motor

526 BAE Screw Blower Motor 98%Over BAE Block Bryant Crankshaft – 5 runs Manton Rockers P&P Wet Sump Oil Pump Moroso Oil Pan w/ Oil Lines...

Forum: Noonan Classifieds

Kenny Laughlin posted a new thread.

FOR SALE: Noonan 526 Screw Blower Short-Block

Noonan 526 Screw Blower Short-Block 526 Noonan – 426R Billet Block 98% Motor Short-Deck 4,500 Bore 2” Lifter Spread 65mm CAM New...

Forum: Noonan Classifieds

Kenny Laughlin posted a new thread.

FOR SALE: Noonan 526 Screw Blower 98% over Motor

Noonan 526 Screw Blower 98% over Motor Noonan 426R Block Short-Deck 2” Lift Spread 65mm CAM New Sleeves/Finished hone (done by BAE) New...

Forum: Noonan Classifieds

quickcut replied to the thread Enderle Injection Tuning Help.

Seams your a long way out . You had the pump Flowed. Why did you buy a tune up as well then you will have a nozzles area with main size...

ATT liked WIDEOPEN231's post in the thread Lock-up system.

Lots have found the lockup too abusive to bottom end.Lockup at wrong time and motor will pull the rods out. Like any tool the wrong use...

Jim Starkey posted a new thread.

Enderle Injection Tuning Help

Looking for thoughts, help or suggestions please. I have a 505 BBC with 8-71 on Alcohol 13.1 static compression Enderle Bug Catcher...

Forum: PSI Superchargers Tech Questions

WIDEOPEN231 replied to the thread Lock-up system.

Lots have found the lockup too abusive to bottom end.Lockup at wrong time and motor will pull the rods out. Like any tool the wrong use...

WIDEOPEN231 replied to the thread Setting initial timing on MSD Mag 44.

Most pros run something like grid where you set timing thru computer and use crank trigger. the mag just has to be set to a base and...

WIDEOPEN231 posted a new thread.

Tool steel adjusters

Like most have had a issue of killing adjuster from time to time. Thinking about going nto all tool steel adjusters or at least on...

Forum: PSI Superchargers Tech Questions

WIDEOPEN231 replied to the thread TAD Exhaust Headers.

I have built quite a few sets. If I can get the plates which should not be problem I can have you a set built same week as get them.(...

bill posted a new thread.

m5 methanol

is m5 methanal make more power and do you have to richen it up

Forum: PSI Superchargers Tech Questions