Worn Clutch cross shaft arm

Discussion in 'System One Pit Buzz' started by Mark Flavell, Jan 5, 2016.

  1. Mark Flavell

    Mark Flavell New Member

    Joined:
    Jul 20, 2011
    Messages:
    22
    Likes Received:
    0
    My clutch arm set up is tired & the cross shaft hole is worn out. The clutch arm is made from 1 3/4" x 1/2" thick alloy with the split 7/8" - 48 spline cross shaft hole at one end & a 5/16" hole 5" along for the pedal rod. I have been looking on what seems like endless sites but have not been able to track down a replacement. The much shorter M144 -A unit does not fit for various reasons so a like for like deal would work out best. ANY IDEAS
    Thanks & best regards
    Mark Flav
    UK
     
    #1
  2. Mark Flavell

    Mark Flavell New Member

    Joined:
    Jul 20, 2011
    Messages:
    22
    Likes Received:
    0
    sorry posted in the wrong section.
    Mark Flav
     
    #2

Share This Page