Nostalgia Front Motor TF car For Sale

Discussion in 'Noonan Classifieds' started by Butch Blair, Jan 10, 2015.

  1. Butch Blair

    Butch Blair Member

    Joined:
    Feb 7, 2007
    Messages:
    759
    Likes Received:
    3
    Nostalgia T/F NHRA Heritage Legal for 2014
    Complete running Car


    Rear motor plate to front end is all new with all NHRA updates
    Updated 225” WB/ new Sterling front half with shorty body
    Osborn canards an front wing
    Front & rear complete spare motor plates
    Donovan 429 cu in with after market griddle, able to check all mains with out pulling girdle
    All titanium 10” glide clutch
    Velasco 3.90 crank
    Arias all new pistons
    GRP rods
    T/D rockers
    Smith Bros push rods
    Hot head valve covers (new power coat)
    MSD 44 amp mag (red coil)
    Strange 9 ½” ultra case rear end 40 spline axles
    Carbon fiber brakes
    Real racing wheels, full bead locks with Hoosier tires
    Rob Moore reverser with custom dual sprag unit
    DJ carbon fiber diaper (new certification)
    Complete oil retention oil pan
    Head pads
    Foam fit driver insert
    Engle roller cam / Crane roller lifters
    8 5/8 trick titanium bell housing
    RCD tri drive
    Waterman 20.00 gpm certified fuel pump from Crawford
    Complete dry sump system, System one oil pump
    Hot heads converted set back manifold with Jackson nozzles
    6:71 Retro blower with Korbeco rotors 8mm drive 40 lbs boost @ 9500 rpm
    Taylor blower blanket (new certification)
    Enderle bird catcher / Pete Jackson barrel valve
    Racepac Pro1 computer with burn out recording (loaded)
    AJ Billet Heads with Osborn aluminum exhaust diversion flanges and headers
    Dual fire bottle system
    American Racing front wheels with new late model t/f tires
    New chute packs and pilot chutes (1 chute missing)
    Rear tire covers

    $50,000.00

    Car is located two hrs. from the Las Vegas Drag strip
    Butch Blair 925 229 3572 top fuel776@aol.com
    Parts that could be included with the sale of the car
    One complete AJ head ready to run with Osborn exhaust diversion plate
    Spare Osborn exhaust diversion plate
    12” wide new Real bead lock wheels. 2 ½” backspace, 5 on 5 ½” used set of 1300 M&H slicks
    Lower end & clutch service trays
    Spare motor plate with all attached hard wear
    New GRP 3300 rods with L19 bolts
    Smith Bros push rods, different lengths
    2 Titan complete dry sump oil pumps
    2 new side rails for girdle
    MTI valve spring air gun (used with stainless valve retainers that are in all heads)
    8mm gt pulleys
    8mm blower belt (2)
    Lots of 10” clutch disk and floaters
    Air over hydraulic rear car lift with custom front car ramp
    Custom tow dolly that lifts car and attaches to tow vehicle
     
    #1

Share This Page