MW 11" Center and Chance Billet Lenco drive converter/Can for Sale/Trade

Discussion in 'Noonan Classifieds' started by Soldierboy0098, Mar 10, 2019.

  1. Soldierboy0098

    Soldierboy0098 Active Member

    Joined:
    Feb 17, 2006
    Messages:
    1,194
    Likes Received:
    11
    I would trade one or both of these items for a blower with a similar value. 14-71 High Helix retro blower, Looking for SSI F3 or later or K/F-11, Might even be able to add a little cash for a super nice blower. I would also trade one of the items for a Lenco CS2 3 spd that I can use with my Lenco drive. Call me with what you have.

    MW modular 11" Center section. It has 4.56 gears and the large 1480 series yoke. Has Three 3.80-3.90 test runs on it before my buddy went back to a 10" for the weight savings, gears look like they haven't been ran. You will never break it, probably the only part in racing you can say that about. These cost around $8,000 new I will sell this one for $4,500+sh

    Ex Chuck Anderika NHRA TAFC. Chance Std Converter R35 pump with 20v35 stator, spare 17v32 Stator, Spare hub, Spare o-rings. Another half to make the converter an NXS. This is for the 1 1/4" Lenco drive but may work on a Bruno (Not sure) This setup would be over 7k new. $4,500+sh for all.


    ***Calling or emailing is best, I don't always catch messages on ITA.***

    Thanks,
    Trevor Sherwood
    727-3six4-436eight (Keeps auto dial ers and scammers away)
    Soldierboy0098@yahoo.com
     
    #1
  2. Soldierboy0098

    Soldierboy0098 Active Member

    Joined:
    Feb 17, 2006
    Messages:
    1,194
    Likes Received:
    11
    Also have a new billet NRE short deck intake I could trade as well w/ a spare quick release burst panel assy and divertor. $4,000
     
    #2
  3. Soldierboy0098

    Soldierboy0098 Active Member

    Joined:
    Feb 17, 2006
    Messages:
    1,194
    Likes Received:
    11

Share This Page