Master cylinder bore size.

Discussion in 'Manton Push Rods Top Alcohol Tech Questions' started by willy200, Nov 25, 2018.

  1. willy200

    willy200 Member

    Joined:
    May 26, 2008
    Messages:
    318
    Likes Received:
    0
    I have a N/A smallblock chev powered altered, which has rear brakes only. looking to run low sevens with the new engine we are installing, I want to install front brakes as well. what bore size and master cylinder would be a good recommendation to use.
    Thanks for any suggestions.
     
    #1
  2. rb0804

    rb0804 Member

    Joined:
    Aug 7, 2010
    Messages:
    511
    Likes Received:
    23
    Your best bet would be to call strange and speak to them. It depends on a lot of factors, your pedal ratio, the size of the calipers, whether they are carbon or not, etc. Some of the funny car stuff uses two little reservoirs and master cylinders. Have some information ready about what you have already, the type of master cylinder, your pedal ratio when you call. Don’t ever use silicone brake fluid as you will never be able to get all the air out.
     
    #2
    nitrowannabe likes this.

Share This Page