Intake pushrod oiling issue

Discussion in 'Manton Push Rods Top Alcohol Tech Questions' started by WIDEOPEN231, May 26, 2018.

  1. WIDEOPEN231

    WIDEOPEN231 Member

    Joined:
    Jun 10, 2011
    Messages:
    44
    Likes Received:
    5
    OK FIRED OFF MOTOR and all was well for few seconds. Got to running rough so figured valve train. Left side great. Right side ate all 4 intake adjusters. push rods where lubed before adjusting,but went thru cpl adjustments due to other things. Not ruling out bad lube on start up . Also wanting to cover my butt and try to not over look something else.

    Pulled rockers off and pulled intake side shaft. Grooved one side and drilled other. I think I know answer to this,but which lines up with feed hole slot of hole?
     
    #1
    Last edited: May 26, 2018
  2. WIDEOPEN231

    WIDEOPEN231 Member

    Joined:
    Jun 10, 2011
    Messages:
    44
    Likes Received:
    5
    Going to run oil line to end of shaft for intakes and thinking of enlarging feed hole one drill size also.
     
    #2
  3. mogenss

    mogenss Member

    Joined:
    Feb 4, 2012
    Messages:
    96
    Likes Received:
    3
    Can you put the whole setup back on the engine, pull the plugs out of the shafts and prime the oil system with a drill ?

    That will tell you if you have a oil feed hole misalignment somewhere
     
    #3

Share This Page