Engine won't run on crank trigger

Discussion in 'Manton Push Rods Top Alcohol Tech Questions' started by bossman, Jul 21, 2018.

  1. bossman

    bossman Member

    Joined:
    Jul 10, 2009
    Messages:
    45
    Likes Received:
    0
    The engine will start and run fine on the mag, as soon as I switch it over to the crank trigger the motor stops. Its a 44 mag with a grid and all the ignition just came back from Electrimotions .
     
    #1
  2. Critical Mass

    Critical Mass Member

    Joined:
    Aug 5, 2010
    Messages:
    160
    Likes Received:
    3
    First thing that comes to mind is phasing. Make sure that the crank trigger is facing one of the magnets when the mag is on #1.
     
    #2
  3. Mike Canter

    Mike Canter Top Dragster
    Staff Member

    Joined:
    Mar 10, 2004
    Messages:
    4,261
    Likes Received:
    101
    So you have the cranktrigger plugged into the gray cable going to the Grid and you the white wire from the Grid going to the upper plug on the mag?
     
    #3
  4. bossman

    bossman Member

    Joined:
    Jul 10, 2009
    Messages:
    45
    Likes Received:
    0
    I found the issue. broken wire on the cross over switch thanks
     
    #4

Share This Page