Coupler Cover

Discussion in 'PSI Superchargers Tech Questions' started by Mac, May 1, 2014.

  1. Mac

    Mac Member

    Joined:
    Oct 8, 2005
    Messages:
    452
    Likes Received:
    0
    Does anyone make a quick release coupler cover for a long tail shaft powerglide?
     
    #1
  2. Mac

    Mac Member

    Joined:
    Oct 8, 2005
    Messages:
    452
    Likes Received:
    0
    I've found some with the stainless quick release clamp but only for a Lenco. Anyone make something for a powerglide?
     
    #2
  3. altered boy

    altered boy Outlaw Altered

    Joined:
    Aug 4, 2003
    Messages:
    418
    Likes Received:
    3
    standard length tail or shorty dragster deal? and what sorta car?
     
    #3
  4. Mac

    Mac Member

    Joined:
    Oct 8, 2005
    Messages:
    452
    Likes Received:
    0
    Long tail shaft in an altered.
     
    #4
  5. altered boy

    altered boy Outlaw Altered

    Joined:
    Aug 4, 2003
    Messages:
    418
    Likes Received:
    3
    I sort of assumed that was the scenario. I know when I originally built my car I also used a powerglide and could not find a good alternative for a coupler and drive shaft cover... like the lencos have. I ended up using a small diameter pair of hoops that have an alum tube/tunnel spanning between them. I just recently switched my car to a lenco/clutch setup. I have the tunnel/hoops if you'd be interested in them? I had them pinned in the car on small stubs/stands
     
    #5
  6. Mac

    Mac Member

    Joined:
    Oct 8, 2005
    Messages:
    452
    Likes Received:
    0
    I'd be interested for sure. I tied sending you my email but your PM's are full
     
    #6
  7. altered boy

    altered boy Outlaw Altered

    Joined:
    Aug 4, 2003
    Messages:
    418
    Likes Received:
    3
    shoot me an email spankycuts@aol.com
     
    #7

Share This Page