BME Rods , Racepak, Enderle, Lenco

Discussion in 'Noonan Classifieds' started by Mark Leigh, Jul 30, 2018.

  1. Mark Leigh

    Mark Leigh Member

    Joined:
    Mar 9, 2010
    Messages:
    420
    Likes Received:
    2
    Pro II dash cable 40 in long - 30.00
    Pro II Analog Cable 168 in long - 25.00
    Contact Closure Driveshaft Sensor -40.00
    Inductive RPM pickup with cable-120.00
    Pro II original style transducers- 25.00 ea
    0-5
    0-5 volt out-2 of these
    G/M
    1- 3 inch belt idler pulley aluminum -new - 100
    SD Cartridge reader module - no chip - 200
    Lenco front case bearing -- low drag CS-1 --75.00 new
    Enderle 16 line manifold injector line set , 225.00

    BME Fuel Rods circa 2012 vintage inspected by BME , low run count 50.00 each , I would run them tomorrow if I was still doing it . 1.156 pin dia.

    Typically 1.600 at the pin down to 1.470 , 1.00 at the big end

    1- 6.921 one run
    9- 6.931 10 run down to one run
    4- 6.950 4 to 0 runs
    4- 6.960 4 of new

    Stroud CS-1 2 speed Lenco Kevlar Blanket , 509K-great condition , needs current cert. 150.00

    If you need pictures or any info please call Mark 209-617-8554
     
    #1
    Last edited: Aug 12, 2018
  2. Mark Leigh

    Mark Leigh Member

    Joined:
    Mar 9, 2010
    Messages:
    420
    Likes Received:
    2
    Bump -- will consider any offers !
     
    #2
  3. nitrostacker

    nitrostacker Member

    Joined:
    Nov 3, 2009
    Messages:
    105
    Likes Received:
    0
    #3

Share This Page