Blower cooling nozzles

Discussion in 'PSI Superchargers Tech Questions' started by Nemo963, Jun 12, 2017.

  1. Nemo963

    Nemo963 Member

    Joined:
    Aug 11, 2014
    Messages:
    31
    Likes Received:
    4
    Running a 10-71 TBS blower on a top Dragster. Have 8 nozzles on top of the blower and then 8 more port nozzles. Happy with the tunability, happy with the distribution of the fuel (by looking at plugs), but looking at the top of my blower and I don't run the two rear nozzles (plugs on the blower case). do I need to plug two plate injectors and move the lines to the rear? If so just use the same Oro face size that was in the plate injectors I move? I don't have any plugged ports to ad two more lines for those two plugs.
     
    #1
  2. jay70cuda

    jay70cuda Well-Known Member

    Joined:
    Sep 30, 2009
    Messages:
    1,139
    Likes Received:
    35
    You should run those. Would help extend strip life and keep rotors lubricated. But those nozzle bodies need to be a straight shot into the blower not a 90 degree nozzle.
     
    #2
  3. Comax Racing

    Comax Racing Member

    Joined:
    Sep 20, 2006
    Messages:
    673
    Likes Received:
    7
    Depending on the blower you may have to modify those nozzles bodies. I have a Littlefield and had to cut them off so they don't protrude through and hit the rotors. Don't be alarmed if you need to do this.

    Corey
     
    #3
  4. Mike Canter

    Mike Canter Top Dragster
    Staff Member

    Joined:
    Mar 10, 2004
    Messages:
    4,630
    Likes Received:
    189
    You can also buy the special short squared off nozzle from Good Vibrations
     
    #4
  5. bob szabo

    bob szabo FC / altered

    Joined:
    Jun 30, 2005
    Messages:
    118
    Likes Received:
    4
    #5

Share This Page