Best O-ring material

Discussion in 'Manton Push Rods Top Alcohol Tech Questions' started by BEDNAR1320, Mar 10, 2018.

  1. BEDNAR1320

    BEDNAR1320 Member

    Joined:
    Oct 8, 2008
    Messages:
    227
    Likes Received:
    10
    I'm looking at the Mc Master-Carr website at bulk O-ring material to replace the stuff that shrunk in my nozzle plate/blower, they have several different materials available. EPDM, Viton, BUNA, silicone, the BUNA and Viton are available in both hard and soft.

    Any suggestions?
     
    #1
    Gunnyonfuel likes this.
  2. Eric Lourie

    Eric Lourie Member

    Joined:
    Nov 12, 2006
    Messages:
    51
    Likes Received:
    0
    Anchor Rubber Products
    They are in Ct. they supply some Pro teams, they have whatever you may need.

    Eric Lourie
     
    #2
  3. Bjs344

    Bjs344 Member

    Joined:
    Sep 10, 2013
    Messages:
    189
    Likes Received:
    7
    I ordered a roll of high temp silicon from McMaster about 4 years ago. I don't recall my exact thought process, but apparently decided that replacing the silicon occasionally would be my best bet.

    I haven't used much of the roll other than the 1st installation. It grows a little so occasionally I'll trim a small piece off during an r&r. Still soft though.
     
    #3
    Gunnyonfuel likes this.
  4. BEDNAR1320

    BEDNAR1320 Member

    Joined:
    Oct 8, 2008
    Messages:
    227
    Likes Received:
    10
    I'd much rather have it grow a little than shrink like the rubber did.

    I think I'll try the silicone stuff
     
    #4
  5. MaineAlkyFan

    MaineAlkyFan Active Member

    Joined:
    Oct 8, 2006
    Messages:
    269
    Likes Received:
    26
    #5
    Gunnyonfuel likes this.
  6. WIZBANG

    WIZBANG Member

    Joined:
    Nov 8, 2004
    Messages:
    757
    Likes Received:
    1
  7. Gunnyonfuel

    Gunnyonfuel Member

    Joined:
    Mar 13, 2015
    Messages:
    32
    Likes Received:
    1

Share This Page