510 cubic inch Chevrolet blown alcohol engine, manifold to pan.

Discussion in 'Noonan Classifieds' started by DANA WARDELL, Mar 5, 2019.

  1. DANA WARDELL

    DANA WARDELL Authorized Merchant

    Joined:
    Jul 14, 2010
    Messages:
    300
    Likes Received:
    4
    Have a recently freshened 510 cubic inch Chevrolet blown alcohol engine, manifold to pan. GM Gen 6 new wet block before build, ARP head studs, O-Ringed with solid copper head gaskets. 4340 crankshaft, Brooks low run aluminum rods, JE low run 11.5-1 alcohol pistons. Brodix aluminum cylinder heads, springs and retainers, titanium intake valves and stainless exhaust. Crane roller camshaft with Crower roller lifters, gear drive, Smith Bros push rods. Jesel shaft rockers. Front gear drive and alumium front cover, RCD degree wheel Moroso square deep 10 quart dragster/boat oil pan, Titan oil pump. Mooneyham blower manifold and burst panel. Aluminum valve covers with burn down tubes. A lot more plus spares, ready to reassemble and run, has been 6.80's at over 200 mph in a 2200 lb car with a super mild tune up. Nice boat, pro dragster or pro altered engine or CIFCA funny car engine. $15,000

    Have a custom, square Dan Olson 10 quart dragster/funny car/door car BBC aluminum oil pan with oil heater, like new, cost over $1,200, like new-selling for $700

    Have a very nice 14-71 Blower Shop or BDS polished blowers standard opening $2500 each, Enderle polished bug hat, all stainless lines, distribution block, was run on above engine $800

    Front blower set up, black anodized MAX idler plate, 3" idler, RCD remote starter bracket, black anodized CNC throttle bracket, custom stainless belt guard and hardware, spacers, etc. $500
     
    #1
    Last edited: Mar 21, 2019 at 6:19 AM
  2. DANA WARDELL

    DANA WARDELL Authorized Merchant

    Joined:
    Jul 14, 2010
    Messages:
    300
    Likes Received:
    4

Share This Page