3" main bearrings

Discussion in 'PSI Superchargers Tech Questions' started by lonnie, Dec 23, 2006.

  1. lonnie

    lonnie New Member

    Joined:
    Dec 28, 2004
    Messages:
    255
    Likes Received:
    0
    anyone know if someone makes a bearring that can be used in a block with 3" mains with a std. hemi journol crank,maybe its a stupid question, but i am sure someone here knows the answer,thanks in advance,lonnie
     
    #1
    Last edited: Dec 23, 2006
    lonnie, Dec 23, 2006
  2. ITS IN MY BLOOD

    ITS IN MY BLOOD TAFC

    Joined:
    Dec 2, 2004
    Messages:
    1,093
    Likes Received:
    2
    It cant be done,...
     
    #2
    ITS IN MY BLOOD, Dec 23, 2006
  3. KMS

    KMS New Member

    Joined:
    Nov 24, 2003
    Messages:
    129
    Likes Received:
    0
    have the block machined to accept a saddle for the smaller bearing dia.
     
    #3
    KMS, Dec 23, 2006
  4. lonnie

    lonnie New Member

    Joined:
    Dec 28, 2004
    Messages:
    255
    Likes Received:
    0
    that what i was thinking,if the main studs are in the same location ,could you just install saddles in the block them line bore using main caps from a block with the smaller dia. crank,may be just easer to buy a 3" main crank
     
    #4
    lonnie, Dec 23, 2006

Share This Page





XenPorta 2 PRO © Jason Axelrod from 8WAYRUN.COM