10" ring gear

Discussion in 'Manton Push Rods Top Alcohol Tech Questions' started by GTPerf, Mar 15, 2017.

  1. GTPerf

    GTPerf Member

    Joined:
    Oct 22, 2006
    Messages:
    189
    Likes Received:
    4
    I have a mark Williams 9" 3rd member that is apart in a box I can see in the housing where them machined it for a 10" gear, my question is the pinion support , what mod's did they have to do to make the pinion support work out for the 10" gear set ? pinion support is not with it now what am I looking for ?
     
    #1
  2. HootersFunnyCar

    Joined:
    Nov 27, 2003
    Messages:
    201
    Likes Received:
    2
    On the Strange center section you need a 1/4" spacer for the pinion support or a pinion support designed for a 10" gear.
    I would assume it is the same for a Mark Williams center.
    Maybe phone them or check website?
     
    #2
  3. HootersFunnyCar

    Joined:
    Nov 27, 2003
    Messages:
    201
    Likes Received:
    2
    BTW love my Motive 10" gear. After going through two bad Richmond 9.5" that made a total of 7 runs first set then 1 run second set before becoming cracked and noisy the Motive 10" went all season and is going back in for another season.
     
    #3
  4. Marc White

    Marc White Member

    Joined:
    Nov 21, 2005
    Messages:
    161
    Likes Received:
    3
    Give Greg Miner a call @ 209 329 7570. We got a 10" gear and pinion support for our Toploader from him. Worked out perfectly and its on year 2 with no issues.
     
    #4

Share This Page