Separate names with a comma.
Could anyone help identify brand of this clutch? I need clutch stands to make it complete. I think it’s a early crower. Would any one guess a...
trying to find a 16x16 5 inch backspace wheel. Prefer a 4 3/4 alumastar center but I can change centers Looking for a gold 24 bolt to fix my...
I have done a search but not much luck. any ideas to renew carbon fiber tubs? I have a set in a car i bought thats only 5 yrs old and they look...
Hggffyyfygtyu
I recently lost a motor and in the process of rebuilding and have a choice of combination. i had a tfx, 4.310 bore, 1.156 pins, 4.5 stroke for...
is there a difference on bypassing fuel on the 2 step between a converter car and clutch car? i would think a clutch car on the 2 step at 5000...
ok i finally got all the parts in to set up a crank trigger and 8973 and have a few questions. 1- I can only set up the crank trigger on the...
I am going to try the 8973 to help control timing in a converter car. I have tried to read all the post in archieves and if I read right the major...
not sure were to post, but thank you for our personal best time! For you to come out to the race track and introduce yourself to to a poor boy...
I know this has been asked a hundred times, but I never seen very many responces and a search did me no good. I need to buy some 6061-10 and with...
Any one know where I can get clevite hemi main bearings and rod bearings 10 over. I was told they were not available in the main bearings by...
I have a 3200# door car wanna be pro mod, 526 hemi,bruno lenco 2 speed with a 1.68 first gear, 4.10 rear gear, 33.5 hoosier co7 tires. This is my...
anyone recommend someone in the austin texas area to time a 1471 blower? had to replace front gears and need to reset the timing. tryed piranio,...
I have recieved a older barry grant fuel system professor II pocket computer which is made by SHARP #pc-1270 for predicting corrected air,tune ups...
Could any one tell me a formula for converting weight into ET? I know 100# is approximately a 10 tenth in the quarter, but what about the 1/8 th...
Can any one give me a pointer on a economical way to electric shift a bruno/lenco combo? I have heard of a few guys using ACD controllers.I have...
Can anyone recommend a good quality valve lash adjusting wrench for a AJ hemi? i have tryed several from jegs etc and the are junk, broke after a...
Would any one help me solve a wiring question? I am running 2 -12 volt Batteries in series for 24 volts for the starter. I tie into 1- 12 volt...
I have seen on here recently how much oil in a hemi, but a search came up with nothing. So here it is again. I have a tfx, aj headed hemi with...
526 tfx aluminum hemi. started last nite for the first time and used the accusump to prime 60 psi before the start, fired right up and pegged my...