Separate names with a comma.
Anyone run a PSI screw B rotor? What overdrive did you run? I did a search and found some info, but not really overdrive specific info. I am...
Anyone have a vendor for some KB Oldsmobile or have a company that would be able to make a custom set? I’m trying to piece one of our blocks...
Will small percentages of nitro tolerate being on the rev limiter/two step? I’m thinking somewhere in the 20% range.
looking for a KB Olds block with the DRCE pattern. Let me know what you have. Thanks Rob 302-463-8018
Has anyone ran the 8 plus box? Have you exceeded its capacity? Pros, cons, issues? I’m seeing they compare it to a 20 amp mag.
Looking for a set of 481x cast mag covers. Let me know what you got. Thanks. Rob 3 zero 2 463 8018
looking for 481x valve covers stage 1-3 thanks. Rb0804@aol.com
does anyone know off had at what bolt circle diameter the 4 bolt flange is on the Enderle and other type pumps? So basically what the measurement...
Anyone run the Hoosier N/TF tire? What size rim? Any better or worse than the M&H’s? Anyone have a current part number, I found one but suspect...
Anyone have any flow figures that they would like to share for a .180” orfice nitrous solenoid? I know the orfice is listed as .180” but I’m not...
anyone have any experience or stories about a freshly built or paved facility? Just curious, I remember there were issues at Charlotte several...
how big should a catch can be for a Lenco drive? How much is normal for it to push out? Should I expect to see 1/2 a quart on a normal run? What...
seriously, where is the parody? Is NHRA paying attention to the stellar numbers being put up by A/Fuelers? Will there be rule changes after this...
I was searching around the site looking for some common fixes for Pro Mag 44 issues. Most threads were about not starting, no spark, not enough...
What’s everyone’s thoughts on hat vs port fuel distribution? 50% in the hat 50% in the ports? Seems like it should be a pretty good balance of...
How does the down nozzles rail seal to the fittings in the side of the head? I was looking at the ones RBS has for sale and it looks like they...
what’s the difference between having a fabricated sheetmetal housing or one of the aluminum strange or Mark Williams modular? One stronger than...
Anyone have any data on mid plate distance from the center of the rear on a dragster? I did a search last night and found some good information on...
how do you guys adjust for weather? Put the info in the Davenport software and change the main jet, change the pump loop, or do it with a timer?...
New to the Hemi stuff, what are you guys running for valve springs on the exhaust side? I am currently running the PSI springs on the exhaust that...