Separate names with a comma.
i look to install a lean out on transbrake its better to instal before or after barrel valve ? and i began with what size of jets ?hemi coan...
hi have hemi 3.900 stroke 14-71, 31od rev around 10000rpm ,now its time too change crankshaft ,what is better 6 or 8 counterweights
i need parts for this offset drive .but i don't know what compagny build ,i need lower shaft ,gear,bushing in block (bae) [IMG] [IMG]
i have a BAE with4.310 bore I can bore these sleeves to 4.375 bore .if possible what is best way to make this
What seat pressure should I set-up my valve springs on Bae 5 with 296-500 ,victory valve. roots 35psi and 10000 rpm
i have a coan super mega convertor and 3 speed lenco shift 9500rpm .convertor slip 0.05 % before shift and at the end of track i would like to...
what is the maximum stroke i can put on bae -500 deck for keep safe rod ratio with 4.375 bore
air gap nylatron and case at how mutch air gap its time too restrip blower . i have 14-71hh front dishard and with a long feeler gage 0.011 pass...
i have lenco cs2 3 speed 1.77 first gear 1.31 second 1.1third its a blower car hemi bae with brad5, 3.9 stroke roots blower around 1900 hp 4.57...
i run lenco 3 speed with coan converter ,i have air cylinder on throttle and 2 steps ,is it better run air cylinder or 2 step? and if a run only...
what is the maximum fuel pressure for an alcohol systhem.220 psi is too high bae roots
how mutch oil i need in hemi bae with moroso FUNNY CAR PAN with accusump(3) thank ita .eric
i would know if i need to ground the negatif of coil on frame same on red coil??? thank for your reply.
around what height is a 34.5x 16 at 210mph
last season i run a 468ci bbc 10.5 cr 14-71 hhr enderle 990 bird 29% od 0.090 in pump loop .around 0.090 main ,square barrel valve . 6x .055 in...
i would know if i can use 14mm belt on 13.9 pulley
i'm new in lenco i have a lenco cs-2 i need to change gear-set ,now its 1,31 i need around1,44 a guys on ita have a 1,44 32 spline x 27 splines...
i have a datalogger 9305( big box )and i need driveshaft rpm sensor and pressure sensor 200lbs its back order ,idon't know if i can put another...
i can put high speed valve before barrel valve