Separate names with a comma.
Can anyone tell me the oil quantity to go into the lencodrive , this is a three speed and reverser, its the bit with the sump and converter i dont...
i have a three speed lencodrive, there is a bracket underneath with two holes and a bracket on the car that corasponds the two holes, Q do i bolt...
Can anyone help me, i have purchased a car with a datalogger on board, if i open a flap on top of the computer there is a chip (i presume memory...
Hi guys i need infoon a 16 channel Trace craft data logger, screenshots etc, i need to see how it works out your speed 60` 1320` g Thanks
Check this out, i think we are getting there http://www.youtube.com/watch?v=UczpWt9f-_Q Then on to a good run...
Would anyone here have drawings for hemi head stud locations, head blueprints spacings etc, just for a project i am thinking of, any help thanks
Worth a look, This is 18 yr old Jaynes 1st run with this combo, let me know what you think,...
I have a cam fitted, sorry i do not know anything about it, it was in engine ( JP1 HEMI )when bought numbers are 659565 and 9111a, before timing...
Does anyone have drawing or measurements for motor mid plate, i have hemi to can at the moment but may need bbc to glide and would like to save...
i am currently running 4.250 crank, in standard height block jp1, i may have the chance of 4.500 crank, will this rotate ok and will i be able to...
the numbers on the end of the cam are 659565 and 9111a journals are gear end 2.00, 1.981, 1.966, 1.950, 1.746 this cam was in the engine when i...
Does this sound right, inlet opening 80 BTDC close 70 ABDC fully open 80 to 97 ATDC ex opening 50 ATDC closing 8 ATDC 0.500 lift on a blown 6-71...
i am having difficulty getting down the track, funny car with old jp1, blown hemi, crower three disc pedal clutch and 1.41 1.37 three speed cs1...
Any ideas today i fired up our JP1 blown methanol motor, no problem crank oil press =120 run press = 160, running out of fuel so we shut off,...
I have a eliminator 2 data aquisition race computer, was with car when purchased, but i am short on info, sensors and know how, any help...
Hi guys i need your help again i have just replaced the two speed with a three speed lenco, now i need another driveshaft and couplers, 32...
What type of oil are you using in a cs1 3 spd, in my 2spd i used atf, but have since been told that it would go through clutches for fun, any...
i have been told i have 41% 1st gear and 37% second in a cs1 three speed how would this equate to gears? i hope this is clear to understand, thanks
Could you help i need the weight of a three speed plus reverser shipping weight thanks for your help
Could any one enlighten me to the reasons for base pressure and finger weights, i have used 2 turns and removed weight, but not realy knowing why...