Separate names with a comma.
Are they still in business? Tried calling, says phone has been disconnected. Their website said they are moving Dec1st. Need my blower restraint...
Does anyone have experience with measuring boost at the rear of the intake vs the front? Just wondering if there is much of a difference, if any.
I am wondering if anyone has used these in a blown alcohol engine. They are quite a bit less expensive than a Bryant/Winburg/Crower etc. There...
I among several others have experienced crankshaft failures (broken in two) at the front rod throw in our blown BBC's. These cranks have been...
In need of a gear drive for a New Century block, RCD no longer offers one, I'm going to call New Century Monday morning hopefully they will have...
On my engine (New Century block) the gear drive front cover has quite a bit of backlash, I haven't actually measured it, but it's about 1° of...
Now that I got my stuck crank hub off I found that it Microwelded itself to the crank snout. That raises the question of how to prevent it from...
I've been around a long time and been doing my own engines for 30 years, never had a crank hub or balancer that I could not get off until now. BBC...
I'm looking for a shop that can put a O-ring groove in the top of my intake so I don't have to use a gasket. Anyone have suggestions? The closer...
I would like thoughts on what effects pinion angle has on a hard tail dragster. My 09 272" Spitzer has about 1.5° up angle relative to the top...
Looking for opinions on what the front end weight should be on a 3.80-3.60 hardtail slipjoint dragster. Car weighs 2040 and is a 272" WB Spitzer...
Wondering how much timing/boost you've run.
Now that Titan is no more, where can I get a Chev distributor gear for a MSD distributor (.500 shaft) for the 5/16" hex oil pump drive that a...
I'm looking at the Mc Master-Carr website at bulk O-ring material to replace the stuff that shrunk in my nozzle plate/blower, they have several...
I run an RCD crank support and the problem I'm having is with the sealed bearing. After only a few passes the seals come out of the bearing and it...
Looking to replace the external oil lines on my engine and I'd like to use the crimped style as I think they are stronger/safer than the normal AN...
It's time for me to replace my 2 piece SFI-15 suit. In the past I have just bought an "off the shelf" suit, but this time I want to do a custom...
I was checking my port check setting and noticed that it will leak very slight, starting about 5# before it actually cracks/opens. This is an...
I am considering adding a fuel flow sensor to my engine. The question I have is, since there is a line from the Enderle K valve to the hat block...
I've searched on here but thought I'd start a new thread to see what everyone's thoughts are for my situation. This is a BBC 12° head deal,...