Separate names with a comma.
Instead of O rings in the head and reciever grooves in the block, has any one used the brass fire rings with the copper gasket there just to seal...
Hi guys, recently changed a set of the 357cnc BBC heads due to a valve head dropping with a new set of there 385cnc heads. We also set back the...
What gauge are you guys using on rods like the GRP rods for hemi or 481X engine. The ARP # 100-9942 tool just doesn't fit into the rod unless I...
Curious to see what heads you guys think work good on a blown Alcohol circuit boat? Will most likely be a 1471 roots. Wondering how the 14°or 11°...
Hi guys, just wondering how much difference you would expect on fuel pressure at the hat and at the ports? My customer has a sensor on the hat...
Just wondering why it has been recommended that when running a cooling system with a blown injected alcohol deal to have a non pressurized cooling...
Just curious on what total timing a SBC with 23° heads would want on the safe side. Engine is 4.125 bore with 3.50" stroke and has a Littlefield...
How do you guys time a MSD 44 mag for initial start up? I've never played with these. No issues with the point type mag as I can see when it will...
Just putting together a 481X & noticed that the manifold is sealed around the ports only with "O" rings. Do you get any oil leaking between the...
Can anyone tell me anythig about BBC olds heads casting #22538816 ? They also have punched on the ends of the heads 706021 & PGR385A2 on one head...
Just curious but can some one tell me if the 481X AJPE block has standard BBCstarter motor provisions?
What do we need to do to clean up the idle & get the "hunting" out on a BBC. What actually causes the hunting? Thanks guys.
We currently are running Blown alcohol circuit boat, BBC powered, & are in the process of rebuilding a fresh engine. It would be nice to go away...
Curious to find out if we have a better option on pistons as we are using CP at the moment on 1471 @ 31%, 28 lbs, 8000rpm max. 10.6:1 comp,BBC...
We have a spare piston that has .00425" piston to pin clearance to be used in a BBC blown alcohol circuit boat.We don't have time or any good...
What is the accepted or should I say correct specifications for the O ring depth compared to the diameter of the wire & how deep should the...
Just wondering if the guys with data loggers could tell what sort of air temp in the manifold would be in relation to the amount of boost, & rpm....
What are you guys using for BBC. If you use copper & 'O' ring the block ,what brand head gasket do you use. How often do you aneal them & what is...
Looking to replace a very worn out set of Pontiac casting # 10045427 and a blower manifold to suit the heads. I spoke to you a while ago & if my...
Typical BBC with a high helix retro 14 blower , set back 4", what sort of nozzle jet size difference would you expect from front to rear on a cast...