Separate names with a comma.
How long can a 44 amp mag be run at one time on methanol. How long till it welds itself. What are the consequences if does. Thanks guys.
What lazer temp gun do you guys use for exhaust header readings...
Can a Bryant crank snout that's keyed be splined, after the fact.
So I brought my hemi to the dyno. I had jon salami do a little flowing of fuel system. I have 2 hi speeds and a pump sizer and a 18.4 gal @ 4000...
Who is cheapest for screw in flowed nozzles and mains. Need a bunch Thanks guys
What would you guys say my min bore would need to be on a blown alcohol hemi KB wet dry block if using my current 2.400 Int and 1.94 Exh valves. I...
How does one know when its time to replace bronze gear in rcd offset mag drive. and can you get one you don't have to drill.
I need a part number or id/od of thrust bearing for 60 mm cam where front journal has a step. Just found mine in pieces. And have not pulled mine...
Where is the best place to get a dingleberry type hone for 4.500" bore. And what grit should i get for conventional dykes.
Where can I find 10 bolt head and manifold torque values and sequence as well as do's and dont's. KB Hemi water block and heads ringed and...
Need a little help! I am re ringing my motor and have been running a CS1702 255 4.505 .017 1/16 3/16. This is a blown hemi on methanol with a...
Has anyone ever run a caged piston in a blown hemi ? Will they work?
Do any of you stack more than 9disks and 11 floaters one being thicker aluminum. To get .100 between alum plate and bottom of snap ring without...
How hard is it to re strip and time a dmpe k11 and can it be done correctly by a first timer? And what is needed to do it? Are there any videos...
So does anyone know how much alum plate and forged rods can stretch before breaking.
Ok here it goes. I had supposedly .090+ piston to head clearance per my engine guy. I had a .052 copper gasket. kb hemi wet dry block with Bryant...
Has anyone tried applying a bead of red silicone around openings on copper head gaskets and allowing it to dry then installing gasket... or should...
Do any of you guys find a particular approach works better than another for sealing a Bryant crank freeze type plug so it does not leak oil. into...
I'm available to help in brainerd MN if anyone need it.