Separate names with a comma.
Switching from a 5 stage dry sump system to a bolt on the block style dry sump pump. i am switching because of the mass of lines needed and i am...
Has anyone used these i have a 481X looking for lifters 904 dia Crower no longer make them morel has body's no tie bars Cranes are junk don't...
What's everyone doing in a pro mod type set up. Hot track more air ? cold less air ? trying to settle an argument lol F/C guys chime in to
We have had some bolt failers with the 90 ft and 120 ft lb bolts .Torque wrenches check good .pan gets dropped after one run and re torqued then...
working on a car with hemi with a chevy /hemi mid plate .Whats the best starter location will have a .500 thick mid plate . Any drawing on block...
What were you guys running for timing pro mag with 45 -50 psi boost
Have twin turbo 481X motor had 40 runs very happy.Dry sump 140psi 60wt oil .0055 bearing clearance mains/rods.last race it was cool out 45 or so i...
Whats everyone running for clearance 1.094 pin high HP boosted engine
Anyone have a drawing or know what the bolt circle and what is the location of the offset hole or are they all the same now its a 11mm 68 tooth...
Helping a friend re strip a older littlefield 14-71 typical older blower half the screws are stripped that hold the strips.so There are nuts...
Switching to 481x seen most are running 16-18 QT oil to keep from sucking pan dry.has anyone run a multi stage maybe 2-3 in pan one in the intake...
I have been cutting my disks for years on a lathe dry with a diamond insert.I use a shop vac to keep the dust down still messy .I picked up a nice...
Are the 9.5 gears any better than the 9''..... looks to be only a 1/4'' and 200.00 deference.
What is the right scale, KG load ,and penetrator type .500 ball ???