Separate names with a comma.
Hi, Have a problem Putting a new build together Noonan heads & Fab Ali covers Fat heads are too short. I have tried. I Need 8 inch tubes Are...
Just setting up a new combo What Mainifold fits Noonan x1 heads BAE 100 tall block Besides Noonan is there any others ??
Just pulling my box apart for a service check. What should I be looking for ? & what do I need to be careful with. I have had this apart a few...
Hi all, Need a new set of rims was looking at Weld AlumaStars 2.0 WE788-616558 Questions, Anyone using them are they good or bad? will the...
Hi, What is better to use Steel or Aluminium Grub screw for blocking off holes in manifold down nozzels Also have a set of Ex-nitro heads that...
Hi, Just hooked a 8973 up a few meetings ago & it ran good. Last meeting I was on the Tranz brake with a air throttle control set @ 4000rpm....
Hi, Just rebuilding my Hemi & can't find my Cam spec sheet/card is anyone running a R-296 / 4778 2S-14 May I have a copy or what is the cam...
Just freshening my Blown Hemi 511 KB Arias pistons Akerly & Childs xtreme rings. 4.375 bore what Ring Gap should I be filling to. 6.5 sec...
Have the chance to buy a bae fuel block Question: Sleeve size now is 4.187 what is the largest I can bore these sleeves to? so I can buy...
Hi, I am going to hook up a 8973 timing controller in the next week or so. Questions: Do I need to use a 8830 capacitor ? Do I have use a...
Lenco Drive what rpm can you rev to when in stage, with out pulling through & frying the clutches. convertor locks up & pull motor down at...
Hi what cam do I need ? I have been Breaking rocker gear left right & centre I think it is coil binding heads have just been serviced....
Ok, Question just freshing my Hemi 4.375 bore Just brought new rings Akerly & Childs Xtreme What gap do I run ? Top? 2nd? Oil? Thanks
Dose anyone know the difference between MB-3248 M & MS- 1795 M Clevite Main Bearings ? I have used the MB before but are not shaw on the MS-...
Hi, Just had a lifter fail after 40 runs kb 511 14/71 running 6.6 @ 205mph Stuffed the cam. Whats a good lifter 904 ? I don't wont needles...
Hi need some help just building a new gooseneck tri axle trailer. 36 Ft towing with F 250 Is it better to load the funnycar in front first? or...
Need to know how a trans-brake lockout works, to prevent the trans-brake from being reapplied after the trans is shifted out of low gear. this...
Hi, Just wan't some advice of fitting Lenco Drive into a funny car 1. Do I still need blow by bar or can I run some kind of rear mount ? as...
Broke rocker gear on both sides of my KB on the weekend NO: 3 & 4 2 broken exhaust rockers, 2 stands, bent shafts in the burn out didn't rev...
Just want to see how you guys are set up your 10inch crower clutch eg base, static weight. Launch rpm When it locks up in a run & rpm. Iv'e...